User manual NILFISK IVB 5 WET-15 QUICK GUIDE

[. . . ] Repairs, when required, should be performed by your Authorized Nilfisk Service Center, who employs factory trained service personnel, and maintains an inventory of Nilfisk original replacement parts and accessories. Call Nilfisk for repair parts or service. Please specify the Model and Serial Number when discussing your machine. The Model and Serial Number of your machine are shown on the Nameplate in the battery compartment. [. . . ] Put one of the black rubber boots over each of the terminals and connect the Battery Pack Connector (15). Turn the key switch off (O) and remove the key, before changing the brushes, and before opening any access panels. 1 2 3 Make sure the Brush Deck (8) is in the RAISED position. Make sure the Key Switch (A) is off (O). To mount the Brushes (AA) (or pad holders) align the Lugs (BB) on the brush with the holes on the mounting plate and turn to lock in place (turn the outside edge of brush towards the rear of machine as shown (CC)). Turn the key switch off (O) and remove the key, before changing the brushes, and before opening any access panels. 1 2 Make sure the Brush Deck is in the RAISED position. Make sure the Key Switch (A) is off (O). Slide the brush into the housing, lift slightly, push and turn until it seats. Fill the solution tank with a maximum of 94. 6 Liters (25 gallons) of cleaning solution. When installing a new cartridge, remove the Cap (AA) and place the cartridge in the detergent box. Be sure you understand the operator controls and their functions. While on ramps or inclines, avoid sudden stops when loaded. This will display the control panel indicator lights, reference the Battery Condition Indicator (F6) and Hour Meter (F1) before proceeding. 3 To transport the machine to the work area, push the Drive Paddle (29) forward to go forward or pull the Drive Paddle (29) backward to move the machine in reverse. vary the pressure on the Drive Paddle (29) to obtain the desired speed. NOTE: Speed Control Knob (30) is used to control the maximum speed in either forward or reverse. 4 Press and hold the Solution Switch (C) for 5 seconds to pre-wet the floor. NOTE: This must be done prior to pressing the Scrub ON/OFF Switch (H). 5 Press the Scrub ON/OFF Switch (H), the scrub pressure will default to Normal (one scrub pressure indicator lit). Use the Scrub Pressure Increase Switch (G) and Scrub Pressure Decrease Switch (I) to change between Regular and Heavy Scrub modes. [. . . ] Wash the tops of the batteries with a solution of baking soda and water (2 tablespoons of baking soda to 1 liter of water). Do not smoke while servicing the batteries. EcoFlex - Charge the batteries each time the machine is used or when the Battery Indicator (F6) is reading less than full. * Remove all jewelry * Do not smoke * Wear safety glasses, rubber gloves and a rubber apron * Work in a well-ventilated area * Do not allow tools to touch more than one battery terminal at a time * ALWAYS disconnect the negative (ground) cable first when replacing batteries to prevent sparks. [. . . ]