User manual NILFISK 03KLU

[. . . ] The maximum working pressure and temperature are printed on the standard high pressure hose. Only use Nilfisk-ALTO high pressure hoses. 2 kp) As the thrust forms an angle with the spray lance, the spray handle is subject to torque. The machine can be connected directly to the mains water supply, or it can work as a selfpriming unit*). [. . . ] Activate the spray handle and allow the rest of the antifreeze to run back into the container. The antifreeze will be diluted with water and will after some time lose its effect. IMPORTANT: To avoid damage always ensure that the cleaner, the hoses and the spray lance are unfrozen before restarting. Place the cleaner and the accessories in a warm place for some time before starting up. The oil should be changed after each 1000 hours' use. Allow the oil to run out and clean the drain plug of impurities. Screw in the plug and refill the pump with fresh oil through the oil glass. From Nilfisk-ALTO the pump is filled with zincless hydraulic oil - Nilfisk-ALTO Pump Oil 100. When refilling and changing the oil this or an oil with the following specifications should be used: ISO no. 130 Pour point below -30°C Concerning oil for mist lubricating, see section. Your Nilfisk-ALTO cold water cleaner is designed and manufactured to comply with the very latest labour regulations. Nevertheless, the following instructions must be strictly observed. Always hold the spray handle and lance firmly in both hands during operation at high pressure. Never direct the high pressure spray towards people or electrical devices. The used oil is caught in a sludge container (pos. 14), which should be emptied before it is completely full. This filter must be taken apart and cleaned regularly. the intervals between cleaning depend on the purity of the water. The filter can be removed, when the quick coupling has been unscrewed. To avoid leakages and damage to the quick couplings on hoses, spray handle and spray lance it is necessary to clean and lubricate the parts regularly with a little oil or grease. Do not disconnect the high pressure hose until the cleaner has cooled down and stopped. Don't attempt to touch nozzle nor water jet during operation. [. . . ] The starting torque is less than the running torque and could vary depending on the position at which the vanes stop in relation to the air intake port. The Nilfisk-ALTO 03K-series of cold water cleaners is produced in several models. The model designation is printed on the model plate, e. This plate provides the following details. [. . . ]