User manual NILFISK MV 4500

[. . . ] The undersigned certify that the above mentioned model is produced in accordance with the following directives and standards. Spazzatrice a 3 spazzole semplice/ Sweeper with simple third broom The purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe and autonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal. Before performing any procedure on the machine, the operators and qualified technicians must read this Manual carefully. [. . . ] Remove the mounting nuts, then remove and replace the wheel. L) carefully by using the lever (10) and lift the wheel (8) until it is slightly detached from the ground. Remove the mounting nuts, then remove and replace the wheel. If it contains a small quantity of material, it is not necessary to empty it. Turn off the engine, by turning the ignition key (6, Fig. CAUTION Proceed at very low speed when towing. The engine must be off (see Diesel Engine Start and Stop paragraph). Lock the wheels by using the wedges (2, Fig. Moving the machine on the trailer bed To move the machine on the trailer bed, perform the following procedures: 1. Use a lift truck having a suitable lifting capacity (35/40 quintals). CAUTION If the lift truck is placed on different points, the machine can get unbalanced. If the machine is not going to be used for more than 30 days, proceed as follows: 1. Store the machine indoor, in a clean and dry place, protected from bad weather conditions and with the following values: · After the first period of use (first 8 hours) it is necessary to perform the following procedures: 1. When installing any equipment, clean the quick couplings before performing the hydraulic connections. NOTE Suction inlet installation is very difficult, so it is recommended not to remove it while using other equipment. Turn off the engine, by turning the ignition key (6, Fig. M) in the plate pin (1), then fasten it with the screw (6). Lower the suction inlet by pressing the lower part of the switch (29, Fig. Lower the left/right brooms by pressing the lower part of the switch (17, Fig. Let the brooms turn on the ground for a few seconds, then perform again steps 9 to 11. Check that the right broom touches the ground along a circle arc ranging from "11 o'clock" and "4 o'clock" and that the left broom touches the ground along a circle arc ranging from "8 o'clock" and "1 o'clock". If the print is not within specifications, adjust the broom tilting by using the tie rods (7, Fig. [. . . ] Turn off the engine, by turning the ignition key (6, Fig. BC), then remove the left rear case (1). Turn off the engine, by turning the ignition key (6, Fig. If the road washer equipment is installed, empty the water tank as shown in Road Washer System Squeegee paragraph. [. . . ]