User manual NILFISK MX 107 C

[. . . ] · Do not pull the machine by the cord, do not use the cord as a handle, close a door on the cord, or pull the cord around sharp edges or corners. Keep the cord away from heated surfaces. To unplug, grasp the plug, not the cord. · Extension cords must be 12 gauge and no longer than 15 m. [. . . ] Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow. · Keep loose clothing, hair, fingers, and all parts of body away from openings and moving parts. · Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes, or any health endangering dusts. Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present. · Turn off all controls before unplugging. · Use extra care when cleaning on stairs. · Liquid ejected at the spray nozzle could be dangerous as a result of its temperature, pressure, or chemical content. 2 INSPECTION: Carefully unpack and inspect your MX 107 C for shipping damage. Each machine is tested and inspected before shipping. Any shipping damage incurred is the responsibility of the carrier. You should notify the carrier immediately if you notice damage to the box or to the machine or parts. CLEANING SOLUTIONS: We recommend liquid cleaning chemicals. Powder chemicals may be used, but unless mixed very thoroughly they could cause a build-up in the pump, lines, and/or quick disconnects. NOTE: liquid cleaning chemical can be added to the water if desired. Follow instructions on the chemical bottle for proper dilution. Do not mix powdered chemicals in the solution tank, mix them thoroughly in a bucket first. Undissolved powder can plug the solution pump, the hose, or the spray tool. Re-install the recovery tank (4) and secure it with the latches (2). Connect the hose assembly (6) to the machine; make sure the quick disconnects are locked together. Plug the power cord into a properly grounded outlet. Turn on the main power switch -- the push button . If the main switch is not turned on, the motors (pump and vacuum) will not turn on with the rocker switch. Set the rocker switch to the UP position to turn on both the vacuum motor and the solution pump. NOTE: with the rocker switch in the DOWN position, only the vacuum motor will turn on. [. . . ] Check the fluid level in the recovery tank (4) periodically. When the fluid reaches the recovery tank full indicator, turn OFF the power switch, unplug the power cord, and move the machine to a designated waste water "DISPOSAL SITE". Do not continue to use the machine after the recovery tank is FULL. Doing so will damage the vacuum motor and damage is NOT COVERED by WARRANTY. [. . . ]