User manual NILFISK MX 585

[. . . ] · Always use solution with a pH between 5 and 10 · Do not allow to be used as a toy. Close attention is necessary when used near children. · Use only as described in this manual. Use only the manufacturer's recommended attachments. [. . . ] Clean the body with an all-purpose detergent, and protect it with an automobile interior polish. Lubricate the wheels, castors, and quick disconnects with an all purpose silicone spray. PARTS AND SERVICE: Repairs, when required, should be performed by your authorized distributor who maintains an inventory of original replacement parts and accessories. Call the distributor from whom you purchased this machine if you need parts or service. Have your serial number handy. Serial Number: __________________ Model: MX 585 MULTIPurchase Date:__________________ Write the name and phone number of your distributor: _____________________________________________ _____________________________________________ (and be sure to register your purchase to active your warranty) 3 SWITCH PLATE MODEL (1): This label identifies the model of your machine. VACUUM SWITCH (2): This push-button switch turns on the vacuum. The switch will illuminate when it is on. 1 MODEL I I I 2 O 3 O O 4 AUTO PUMP OUT SWITCH (3): This switch will turn on the automatic pump-out pump, and it will illuminate when it is on. SOLUTION PUMP SWITCH (4): The pump switch will turn on the 1200 psi solution pump and the switch will illuminate when it is activated. The output pressure of this pump is adjustable through the unloader valve. Refer to the drawing below, and to Set-Up and Operation instructions. YOUR MACHINE Solution Tank Access Recovery Tank Lid Pre-filter Bag Vacuum Hose Connection Recovery Tank Drain Latch X A M X Switches Auto-fill Hose Connection O O O Power Cords Pressure Adjustment Cap 12" Wheel Base The Pressure Relief Valve is inside the base compartment Pump-out Hose Connection Solution Output Castor 4 SET-UP & OPERATION 1. Before each use, inspect the machine, hoses, and cleaning tools for cleanliness and completeness. Make sure hoses are in good condition and the spray nozzle(s) is tight. 2. If not using the auto-dump feature, just make sure the brass cap is on the drain hose connector on the front of the base of the machine. If you choose to use the auto-dump feature, remove the brass cover on the hose connector on the front of base of the machine, attach a hose, and place the open end of the hose in a drain. Make sure the recovery tank drain gate is closed, and the lid is tight on the recovery tank. If you choose not to use the auto-fill feature, just fill the tank with water and cleaning chemical. Follow chemical directions regarding dilution and mixing. Do not use harsh chemicals; they may damage seals in pumps and valves, and cause the pump to wear prematurely. If you choose to use the auto-fill feature, connect the fill hose to the auto-fill connector (located over the solution tank fill hole). Turn on the water source -- HIGH PRESSURE IS NOT NECESSARY -and allow the tank to fill with water. When using the auto-fill system, the auto-fill float will automatically turn on and turn off as the tank empties and then fills. NOTE: Never put water with a temperature exceeding 54 °C in the solution tank 4. Pre-spray the area to be cleaned, with a pump-up sprayer, while the tank is filling. [. . . ] · Turn ON the dump pump switch (switch is located on the switch panel on the top of the machine). · NOTE: the dump pump is `self-priming. ' You should see water start to flow within 30 seconds of the pump turning on. If water does not begin to flow, check the filter to see if it is plugged with debris. · After each job: run clear water though the dump pump to wash out any chemical residue. [. . . ]