User manual NILFISK RS 1301

[. . . ] The undersigned certify that the above mentioned model is produced in accordance with the following directives and standards. AQ) comme indiqué dans la figure (la figure montre l'inclinaison du troisième balai vue du siège de conduite). AQ) comme indiqué dans la figure (la figure montre l'inclinaison du troisième balai vue du siège de conduite). This Manual is an integral part of the machine; its purpose is to provide the operator with all necessary information to use the machine properly in a safe and autonomous way. [. . . ] d) counterclockwise , to the end of stroke , then remove it. Get out of the machine and bring the 3rd broom safety pin from the position (2, Fig. When necessary, empty the dust control system water tanks according to the following procedure. Turn off the engine, by turning the ignition key (24, Fig. Turn off the engine, by turning the ignition key (24, Fig. To tow the machine, fix it to one of the following parts: · After towing the machine, tighten the screw (1, Fig. To transport the machine with a trailer, use the hooks and anchors shown below. The machine is equipped with the following hooks: · B), to be used only when the hopper is empty. Anchor the machine with the front and rear towing hooks (18 and 45, Fig. B), placed over the rear axle support (6), and on the front left and right cab footboards (7) respectively. If it is necessary to lift the machine in case of emergency and the hopper is not empty, pay special attention, because the waste weight can cause the machine unbalance, moreover the hooks are subject to a greater stress. Lift the machine carefully, as shortly as possible, with a suitable hoisting system and according to the accident-prevention rules. If the machine is not going to be used for more than 30 days, proceed as follows: 1. Empty the dust control system water tanks according to the following procedure. Store the machine indoor, in a clean and dry place, protected from bad weather conditions and with the following values: · Deactivate the battery by turning the key of the release device (47, Fig. After the first period of use (first 8 hours) it is necessary to perform the following procedures: 1. After the first 50 working hours, perform checks and replacements shown in the Scheduled Maintenance Table. The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance. the following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions, which are to be defined by the person in charge of the maintenance. Maintenance procedures must be performed when the machine is off (ignition key removed). Moreover, read carefully the instructions in Safety chapter before performing any maintenance procedure. [. . . ] the signals are properly interpreted by the electronic board. The outputs are not provided by the machine control board but by selecting forward/reverse gear properly. The outputs are properly supplied, the reverse gear buzzer sounds, but the machine is not moving. The directional sensors installed on the pedal are damaged or are not reading. [. . . ]