User manual NILFISK S2L

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual NILFISK S2L. We hope that this NILFISK S2L user guide will be useful to you.

Lastmanuals help download the user guide NILFISK S2L.


Mode d'emploi NILFISK S2L
Download
Manual abstract: user guide NILFISK S2L

Detailed instructions for use are in the User's Guide.

[. . . ] This appliance is not intended for use by children or other persons without assistance or supervision if their physical, sensory or mental capabilities prevent them from using it safely. Children should be supervised to ensure that they do not play with the appliance. Before starting up your machine please check it carefully for any defects. If you find any, do not start up your machine and con- tact your Nilfisk distributor. [. . . ] NOTE: Do not place the machine in tall grass!Activate the trigger of the spray handle and let the water run until all air has escaped from the water hose. Turn the start/stop switch (1) to position "I". Activate the trigger of the spray handle. Always adjust the distance and thus the pressure of the nozzle to the surface, which is to be cleaned. Do not cover the machine during operation. Note: If the machine is left or not used for 5 minutes, it must be switched off on the start/stop switch "O" (1): 1. Turn the start/stop switch to position "O". Disconnect the electrical plug from the socket. Shut off the water supply and activate the trigger to relieve the machine of pressure. When releasing the trigger of the spray handle, the machine automatically stops. 30 kg. Nilfisk P 130. 2 / S2L / P 160. 2 5 Fields of application and working methods 5. 1 General Efficient high presure cleaning is achieved by following a few guidelines, combined with your own personal experience of specific cleaning tasks. Accessories and detergents, when correctly chosen, can increase the efficiency of your pressure washer. Here is some basic information about cleaning. EN 5. 1. 1 Detergent and foam Foam or detergent should be applied onto dry surfaces so that the chemical product is in direct contact with the dirt. Detergents are applied from bottom to top, for example on a car bodywork, in order to avoid "super clean" areas, where the detergent collects in higher concentration and streams downwards. NOTE: Use the garden brush to clean off the dirt. Same method as for flagstones, but be careful - bad joints and wood may be damaged by high pressure. You may choose only to use the Tornado® nozzle. Adjust the distance (pressure) to the quality of the joints and the wood. Patio Cleaner can also be used on vertical surfaces. Rims, aluminium Rim brush, atomizer, Alu Cleaner Powerspeed® nozzle, Stone & Wood Cleaner, Patio Cleaner Wood Cleaner Garden brush Flagstones, concrete floors and other hard surfaces Garden furniture, wood Brickwork, Powerspeed® Wood nozzle, work Stone & Wood Cleaner, Patio Cleaner Gutter Underchassis spray Wash the gutter with the underchassis spray lance. ½ m (to mark) into a tube or drain and activate the trigger of the spray handle. The nozzle opening turning backwards will pull the cleaner through the tube. [. . . ] Wait for pump/hoses or accessory to thaw. Clean the filter (see section 7. 1) Clean the nozzle (see section 7. 2) EN Machine refuses to start Machine not plugged in Defective socket Fuse has blown Defective extension cable Fluctuating pressure Pump sucking air Valves dirty, worn out or stuck Pump seals worn out Motor busses Machine stops Low voltage or low temperature Fuse has blown Incorrect mains voltage Thermal sensor activated Nozzle partially blocked Fuse blows Fuse too small Machine pulsating Air in inlet hose/pump Inadequate supply of mains water Nozzle partially blocked Water filter blocked Hose kinked Machine often starts and stops by itself Machine starts, but no water comes out Pump/spray handle is leaking Pump/hoses or accessory frozen No water supply Water filter blocked Nozzle blocked In case problems other than the above occur, please contact your local Nilfisk distributor. UK: Customer Services at Penrith - 01768 868995 15 Nilfisk P 130. 2 / S2L / P 160. 2 EN 9 Further information 9. 1 Recycling the washer Make the old cleaner unusable immediately. Unplug the cleaner and cut the electric cable. Do not discard electrical appliances with household waste. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE NILFISK S2L

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual NILFISK S2L will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag