User manual NILFISK SCRUBTEC BOOST R

[. . . ] Pour enlever la brosse / plateau support disque, il suffit de soulever la tête en appuyant sur la pédale (11), puis appuyer sur le bouton-poussoir (75) et attendre jusqu'à ce que la brosse / plateau support disque tombe au sol. REMARQUE Pour un lavage / séchage correct du sol près du mur, Nilfisk Alto recommande d'approcher le côté droit de la machine, comme illustré dans la figure 3. The purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe and autonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal. [. . . ] Pay attention when using sulphuric acid, as it is corrosive. If it comes in contact with skin or eyes, rinse thoroughly with water and consult a physician. Fill up the battery cells with sulphuric acid for batteries (density 1. To avoid damaging the floor, dry with a cloth both acid and water on the top of the batteries after charging. Let the batteries rest and fill in with sulphuric acid as shown in the Battery Manual. Set the machine and the battery charger (if equipped) according to the type of batteries installed (WET or GEL) as shown in the following paragraph. Set the electronic board of the machine and of the battery charger (if equipped) according to the type of batteries installed (WET or GEL) according to the following procedure: Turn the ignition key (80) to "I" and pay attention to the following in the very first seconds of machine operation: · If the green warning light (81a) is flashing, the machine is set to GEL. If the setting is to be changed, perform the following procedure. Turn off the machine by turning the ignition key (80) to "0". Press and hold the switches (71) and (73) at the same time, then turn the ignition key (80) to "I". Release the switches (71) and (73) at least 8 seconds after starting the machine. Open the cover (22) and check that the recovery tank (21) is empty, otherwise empty it with the drain hose (16). Fill the tank (45) with a detergent suitable for the work to be performed (highly concentrated detergent). Do not fill the detergent tank completely, leave a few inches from the edge. , wait for the hoses to fill up, before starting the Chemical Mixing System. Insert the ignition key (80) and turn it to "I". Check that the green warning light (81a) turns on (charged batteries). If the yellow or red warning light (81b or 81c) turns on, turn the ignition key back to "0" and charge the batteries (see the procedure in Maintenance chapter). drive the machine to the working place: · By pushing it with the hands on the handlebar (2) (only for SCRUBTEC 545B and 553B). By pushing it with the hands on the handlebar (2) and pressing the switch (83) to move forward, or pressing the switch (83) together with the switch (78) to move rearward (only for SCRUBTEC 545BL, 553BL and BOOST 5). The forward speed can be adjusted with the adjuster (84). Lower the squeegee (25) with the lever (10). [. . . ] NOTE The hole (K), allowing to compensate the air in the cover air gap, contributes to create vacuum in the tank. Turn the ignition key (80) to "0". If necessary, drain the water from the tank in order to make the filter visible. If necessary clean it with water and compressed air, then install it. [. . . ]