User manual NILFISK SM 800

[. . . ] Contact your Nilfisk Dealer for any repair or service, and specify your machine model and serial number. Nilfisk constantly improves its products and reserves the right to make changes and improvements at its discretion without being obliged to apply such benefits to the machines that were previously sold. Any change and/or addition of accessory must be approved and performed by Nilfisk. Upon delivery check that the packing and the machine were not damaged during transportation. [. . . ] Do not use the machine when tired, absent-minded, under the effect of drugs, alcoholics or medicines which can compromise the control over the machine. General Cleaning width with side brooms Main cylindrical brush cleaning width Machine size with folded handlebar (length x width x height) Machine size with unfolded handlebar (length x width x height) Main broom size (diameter x length) Side broom diameter Collection tank capacity Machine total weight Values 820 mm 450 mm 890 x 820 x 345 mm 1, 300 x 820 x 1, 030 mm 150 x 450 mm 260 mm 34 L (theoretical) - 19 L (actual) 16 kg This sweeper has been designed to clean flat and paved surfaces. The manufacturer is not responsible for damages coming from failure to follow these instructions. The manufacturer is not responsible for damages coming from unauthorised machine modifications. If necessary, adjust the handlebar (1) to one of the 3 positions, by using the knobs (2). Grab the handlebar and push the machine forward no faster than a normal walking pace. If the machine is to be used on wet floors, use it only for short intervals. The collection tank (3) should be emptied after each working cycle and whenever it is full. Lift the collection tank with the handle (4) in the front side and empty it into a proper container. Install the collection tank on the machine by inserting the lower end into the machine frame (12). Slightly press downwards until the collection tank is in the proper position. It is advisable to empty the collection tank after each use and whenever it is necessary. After working, before leaving the machine: empty the collection tank (4) and check the main brooms (8 and 9) to remove foreign materials (lace, wire, strings or similar) which can compromise the proper operation. ­ Fold down the handlebar and lock it. Only perform the maintenance procedures described in this Manual. for other procedures , contact the Service Center. Use only Nilfisk original spare parts and accessories. The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance. Procedure Place the machine in a vertical position Empty the hopper (3) Clean the main (8 and 9) and side brooms (6) Clean the machine Replace the main broom (9) when worn Replace the side brooms (6) when worn Replace the driving belt (*) After working Monthly When necessary After each use, perform the following procedures: ­ Empty the collection tank (3). ­ Check if there are foreign objects caught in the brooms or wheels and remove them immediately. ­ Clean the brooms and remove any lace, wire, strings or similar, which can compromise the machine efficiency and cause damages due to the drive system sticking. ­ Periodically check the side brooms for wear and replace them when the bristle length is reduced to 1/3. [. . . ] Place the machine in a suitable place, with the bottom side up. Except the procedures shown in this Manual, the operator should not try to perform other repair procedures on the machine. repair and services must be performed by Nilfisk authorize technicians. The following instructions should be useful to solve some machine problems. [. . . ]