User manual NILFISK SO4500

[. . . ] · This machine is intended for use in a commercial cleaning environment. If you do not follow the instructions contained in this manual, situations may arise which may be dangerous or harmful to the machine or the person operating the machine. Read this manual carefully so that you know when such situations can arise. Ensure that all operators of this machine are fully trained on how it works. [. . . ] Plug the power cable into a 240 Volt supply. Inspect the electric cable before every use. If the cable becomes damaged at anytime the complete cable must be replaced by a Nilfisk ALTO approved distributor. Never touch the power cable or plug with wet hands !! Always unplug the machine when i. Any maintenance work is being carried out 8. Switch the On/Off switch (Number 7 Diagram B) to the ON position. The Heater On light LED (Number 8 Diagram B) will illuminate. Allow approximately 5 minutes for the boiler to heat the water 10. When the Steam Ready LED (Number 9 Diagram B) illuminates the machine is ready to be used. · The fan switch on the hose handle will release steam when pressed. · Pressing the detergent switch located on the top of the handle will activate the detergent pump. Hold the switch as long as you need to dispense the detergent. Releasing the switch will stop the detergent supply. The steam output can be adjusted by the steam control knob (Number 2 Diagram A) 13. Choose and fit the required accessory (Diagram C) to the hose handle. !! When changing accessories during use please note these will be hot. 8 English During Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Cold Water Tank Empty(Number 1 Diagram A) 1. Refill the cold water tank when the refill cold water LED (Number 11 Diagram B) is illuminated. A buzzer will sound and the steam will no longer come out of the nozzle when the steam switch on the handle is pressed. The pumps will not work when the cold-water tank is empty. Once the cold water refill LED is illuminated the boiler heater will remain on for 30 minutes. If the cold-water tank is not refilled within 30 minutes and the machine is left powered on the boiler heater will switch off. Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . This machine is to be used by trained operatives only DO · · · · DON'T · Use the machine near people, children or animals · Point steam at electrical apparatus · Use the machine to clean the machine down · Do not use on Velvet, satin or leather · Leave the machine unattended Check the cable and plug are safe and intact before plugging the machine in. [. . . ] · We shall not be liable under this guarantee for any fault in the appliance arising from the use of spare parts not supplied and recommended by us. · Excluded from this guarantee are parts that need replacement due to normal wear and tear such as hoses, nozzles and accessories. 11 English Technical Technical Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Boiler Wattage: Type: Capacity: Continuous Fill Steam Pressure Steam at source: 1950W Powder Coated 1. 8 Litres Yes 4. 5 Bar 135°C > Electrical Voltage Low Voltage Controls Cord length 230V ~ single phase 5V 10m Capacities Boiler Cold Water Tank Weight 1. 8 Litres 5 Litres (easy fill) 12kg 12 English Trouble Shooting Symptom No power Possible cause Not connected / Faulty socket Action Check connection to wall socket and socket switch. Try in another wall socket Press On / Off switch which will illuminate when on Replace fuse with approved 13A fuse Call for service Turn the control to half way Wait for the "Ready to steam" light to illuminate Pour water into the clean water tank until the beeper stops. Call for service Wait for the "Ready to steam " light to illuminate Hold the steam switch on for approximately one minute, ever if just water is coming out. [. . . ]