User manual NILFISK SR 1000S B

[. . . ] The undersigned certify that the above mentioned model is produced in accordance with the following directives and standards. Contrôler la hauteur du sol des balais latéraux, en procédant comme suit : ­ porter la machine sur un sol plat et baisser les balais latéraux ; ­ en gardant la machine en position d'arrêt, baisser les balais latéraux et les faire tourner pendant quelques secondes ; ­ arrêter et soulever les balais latéraux, puis déplacer et arrêter la machine ; ­ contrôler que la trace laissée par les balais latéraux est, en extension et orientation, comme indiqué dans la figure (1 et 2, Fig. The purpose of this Manual is to provide the operator with all necessary information to use the machine properly in a safe and autonomous way. It contains information about technical data, operation, storage, maintenance, spare parts and safety. [. . . ] C) is equipped with a safety sensor, which allows the machine to be driven by pressing the pedal (5, Fig. Turn on the vacuum system with the lever (3, Fig. C) can be lowered and lifted even when the machine is moving. The side brooms do not rotate when they are lifted, but they rotate when they are lowered. C) and move the machine forward by pressing the pedal (5). The machine factory setting is for lead (WET) batteries. If this setting corresponds to the type of batteries installed on the machine, go to the next paragraph, otherwise perform the following procedures: ­ Disconnect the battery connector (6, Fig. Make sure that there are no open doors/hoods and that the machine is in normal operating conditions. If the machine has not been used after being transported, check that all the blocks used for the transportation have been removed. In case of emergency, press the emergency push-button (12, Fig. To deactivate the emergency push-button (12), turn it clockwise. To turn off the main broom and the vacuum fan, turn the switch (9, Fig. Engage the parking brake according to the following procedure: ­ Press the pedal (6, Fig. C) as necessary, then engage the brake by turning the lever (7, Fig. C) by using the handle (22), and dump it into special containers. reinsert the hopper and fasten it with the hook (21). The machine is ready to start working again. After working, before leaving the machine: ­ Lift the side brooms with the lever (4, Fig. ­ Engage the parking brake according to the following procedure: ­ Press the pedal (6, Fig. C) as necessary, then engage the brake by turning the lever (7, Fig. Avoid stopping for a long time with the machine in the same position and the brooms rotating: this could create unwanted marks on the floor. To collect light and bulky debris, lift the front skirt by pressing the pedal (8, Fig. [. . . ] If necessary, clean the upper surface of the batteries. Charge the batteries according to one of the following methods, depending on the presence of the electronic battery charger (7, Fig. (For WET batteries only) check the level of electrolyte inside the batteries. If necessary, top up through the caps (5, Fig. [. . . ]