User manual NILFISK SR 1101 MATERIAL COMPOSITION

[. . . ] Nilfisk will not be answerable for damages coming from the non-observance of this prohibition. The User Manual must be kept near the machine, inside an adequate case, away from liquids and other substances that can cause damage to it. The declaration of conformity, supplied with the machine, certifies the machine conformity with the law in force. NOTE Two copies of the original declaration of conformity are provided together with the machine documentation. [. . . ] Start sweeping by turning the steering wheel (72) and moving the machine forward by pressing the pedal (76). In case of emergency, press the emergency push-button (71) to immediately stop the machine. To deactivate the emergency push-button (71), turn it in the direction shown by the arrow. Turn off the vacuum system with the switch (66). Turn off the machine by turning the ignition key (69) to "0", then remove it. Engage the parking brake by pressing the pedal (82), then engage the brake lock control lever (75). Avoid stopping for a long time with the machine in the same position and the brooms turning: this could create unwanted marks on the floor. To collect light and bulky waste materials, lift the front skirt (18) by pressing the pedal (81); take into consideration that the machine vacuum capability is reduced when the front skirt is lifted. When operating on wet floors, it is essential to turn off the vacuum system by pressing the switch (66) to prevent the dust filter from being damaged. For machine proper operation, the dust filter must be as clean as possible. To clean the dust filter while sweeping, turn on the filter shaker for a short interval by pressing the upper part of the switch (66), then turn on the vacuum system by pressing the lower part of the switch (66). If the machine is not going to be used for more than 30 days, proceed as follows: 1. Check that the machine storage area is dry and clean. After the first 5 hours perform the following procedures: 1. Check the fastening and connecting parts for proper tightening; check the visible parts for integrity and leakages. The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance. the following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions, which are to be defined by the person in charge of the maintenance. all scheduled or extraordinary maintenance procedures must be performed by qualified personnel , or by an authorised Service Center. This Manual describes only the easiest and most common maintenance procedures. For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted at any Service Center. To perform maintenance procedures, the machine must be off, the ignition key removed, and, if necessary, the batteries must be disconnected. [. . . ] After a few seconds, unscrew the engine oil level plug (34) again and check that the oil level is between the ADD (minimum level) and FULL (maximum level) marks (A, Fig. Turn the ignition key (69) to "0". Remove the screws (48), then disengage the fasteners (49) to remove the left side bulkhead (47). Clean the engine air pre-filter and/or service the air filter element (A, Fig. [. . . ]