User manual NILFISK SR 1101 P

[. . . ] The undersigned certify that the above mentioned model is produced in accordance with the following directives and standards. The purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe and autonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal. Before performing any procedure on the machine, the operators and qualified technicians must read this Manual carefully. [. . . ] Do not cover these plates for any reason and immediately replace them if they are damaged. The machine needs two 12 V lead batteries, connected according to the diagram (44). The machine can be supplied in one of the following configurations: A) Batteries already installed and ready to be used B) Batteries installed on the machine but without electrolyte C) Without batteries According to machine configuration, proceed as follows. A) Batteries already installed and ready to be used 1. Open the machine hood (7) and check that the batteries are connected to the dynamotor through the appropriate terminals. If the batteries are discharged, charge them with an external battery charger. Pay attention when using sulphuric acid, as it is corrosive. If it comes in contact with skin or eyes, rinse thoroughly with water and consult a physician. Fill the battery cells with sulphuric acid for batteries (density from 1. Let the batteries rest and fill in with sulphuric acid according to the instructions shown in the Battery Manual. Make sure that there are no open doors/hoods and that the machine is in normal operating conditions. make sure that the hopper (17) is properly closed. If the machine has not been used after being transported, check that all the blocks used for the transportation have been removed. If necessary, open the hood (7), unscrew the cap (61), and refuel; then close the hood (7). Do not fill the fuel tank to the top, but leave at least 25 mm from the filler neck to allow the fuel to expand. If necessary, adjust the seat to a comfortable position by using the lever (31). If necessary, use the lever (93) to tilt the steering column (1) forward or backward in order to reach a comfortable position. Always keep the choke lever open before starting the engine: to start this machine, the choke lever is not required. Do not start the engine by using the manual starting cord: the engine is equipped with electrical ignition by starter. Turn the ignition key (82) to "I", then to "II" and start the engine. When the engine starts, release the ignition key immediately; it will go back to "I". When starting the engine with the ignition key (82) do not press the drive pedal (2). [. . . ] Check that distance from the ground of the side skirts (13 and 14) is within 0 ­ 3 mm (A, Fig. If necessary, adjust the skirt height by using the slots on the screws (A, Fig. 12) larger than 20 mm or cracks (B) larger than 10 mm (for skirt replacement, refer to the Service Manual). The distance from the ground of the rear skirt (B, Fig. [. . . ]