User manual NILFISK SR 2000

[. . . ] This manual will help you get the most from your Nilfisk SR 2000. Read it thoroughly before operating the machine. References to "right" and "left" in this manual mean right or left as seen from the driver's seat. Repairs, when required, should be performed by your Authorized Nilfisk Service Center, who employs factory trained service personnel, and maintains an inventory of Nilfisk original replacement parts and accessories. [. . . ] The alarm makes a loud audible noise when the machine is being driven in reverse. sEAT ADJUSTMENT (See Figure 2) This lever (O) is located on the right of the seat. This lever allows the seat to be adjusted forward or back when the lever is moved. pARKING BRAKE (See Figure 8) The parking brake lever (P) is located in the left side of the driver compartment floor. This lever when raised to the upright position will "lock" the foot brake pedal in the down position. The circuit breakers (Q) are located to the left of the steering wheel. When a circuit breaker "pops" out, this is an indication of an electrical problem that must be corrected before the breaker can be reset. There can be up to seven circuit breakers in the row. They control the following circuits, beginning with number 1 on the left: CB-1 = Filter shaker motors CB-2 = Horn CB-3 = Starter relay CB-4 = Ignition CB-5 = Accessory CB-6 = Options CB-7 = Cab Options It is advised that in no circumstances should either or any other unauthorized starting aids be used at the same time as the Glow Plugs. To operate the glow plugs, the following procedure should be adopted. With the "GLOW PLUG" button still depressed, engage the starter motor until the engine starts. Continue to press the "GLOW PLUG" button for a few seconds after the engine has started until even running has been obtained. If the engine does not start, disengage the starter motor but keep the "GLOW PLUG" button depressed for a further 10 to 15 seconds. When a further attempt is made to start the engine, keep the glow plugs energized while starting and for a few seconds after the engine has fired until it is running smoothly. The lever is a three position control that operates the hopper lift, side broom and optional left side broom. NOTE The hopper lift lever will not function until the hopper has been rotated to clear the body of the sweeper. the lever is spring centered from the rear position. The center position turns OFF the side broom (or brooms) and is the HOLD position when dumping the hopper. the lever is detonated in the forward position. Move the lever forward to turn ON the side broom when sweeping or to LOWER (A) the hopper when dumping the hopper. Move the lever back to RAISE (B) the hopper when dumping. Release the lever when the hopper has reached the desired height. [. . . ] The area of broom bristle contact with the floor should be 2 to 3 inches or 5 to 8 cm. The main broom level is factory set and should not need adjustment, if the level gets out of adjustment and the broom bristle contact pattern is not an even 2" to 3" wide, the broom arm lift frame will have to be adjusted. the frame is supported by two flange bearings. These bearings are located inside the broom doors. [. . . ]