User manual NILFISK SW 850S B

[. . . ] / Rok výroby / Baujahr / Fabrikationsår / Año de fabricación / Väljalaskeaasta / Année de fabrication / Valmistusvuosi / Year of construction / / Gyártási év / Anno di costruzione / Pagaminimo metai / Izgatavosanas gads / Byggeår / Bauwjaar / Ano de fabrico / Rok produkcji / Anul fabrica iei / / Tillverkningsår / Rok výroby / Leto izdelave / Leto izdelave/ mal yili : , The undersigned certify that the above mentioned model is produced in accordance with the following directives and standards. The purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe and autonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal. Before performing any procedure on the machine, the operators and qualified technicians must read this Manual carefully. [. . . ] To clean the filter while sweeping, turn on the filter shaker by proceeding as follows and according to the type of filter shaker installed: · manual filter shaker: Turn the ignition key to "0". Pull the handle (20) outward to the end of stroke, then suddenly release it; the inner return spring thus strikes the dust filter frame and shakes it. To start sweeping again, turn the ignition key to "I". During this procedure the main motor and all functions are automatically cut-off. nOTE Repeat the filter shaking procedure at least every 10 minutes. This interval can change depending on the dustiness of the area to be cleaned. Do not work on wet floors to prevent the dust filter from being damaged. The debris container (17) should be emptied after each working cycle and whenever it is full. Turn the ignition key (61) to "0". disengage the debris container hook (18) by pulling its lower end. With the handle (19) remove the debris container (17) and empty it into an appropriate container. install the debris container (17) and engage the hook (18). The machine is ready to start working again. After working, before leaving the machine, perform the following procedures. Clean the dust filter with the manual filter shaker (20) or the electrical filter shaker (67), if equipped. Make sure that the machine cannot move independently. The machine can be pushed both with the ignition key (61) to "0" and to "I". If the machine is not going to be used for more than 30 days, proceed as follows: 1. Check that the machine storage area is dry and clean. After the first 8 hours, check the machine fastening and connecting parts for proper tightening and check the visible parts for integrity and leakage. The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance. the following table provides the scheduled maintenance. [. . . ] If necessary, clean the upper surface of the batteries. Charge the batteries according to one of the following methods, depending on the presence of the electronic battery charger (34). After charging, disconnect the external battery charger from the electrical mains and from the connector (33). (For WET batteries only) check the level of electrolyte inside the batteries (32). [. . . ]