User manual NILFISK SW 850S P

[. . . ] / Rok výroby / Baujahr / Fabrikationsår / Año de fabricación / Väljalaskeaasta / Année de fabrication / Valmistusvuosi / Year of construction / / Gyártási év / Anno di costruzione / Pagaminimo metai / Izgatavosanas gads / Byggeår / Bauwjaar / Ano de fabrico / Rok produkcji / Anul fabrica iei / / Tillverkningsår / Rok výroby / Leto izdelave / Leto izdelave/ mal yili : , The undersigned certify that the above mentioned model is produced in accordance with the following directives and standards. The purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe and autonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal. Before performing any procedure on the machine, the operators and qualified technicians must read this Manual carefully. [. . . ] ­ Never run the engine if the air filter is not installed, because the engine could be damaged. Technical service procedures on the engine must be performed by an authorised Dealer. ­ Only use original spare parts or parts of matching quality for the engine. Using spare parts of lower quality can seriously damage the engine. Control panel Lifted side broom fastener Handlebar Drive lever Handlebar adjusting knobs Can holder Hood Rear driving wheels on fixed axle Front steering wheel Side broom Main broom Side broom lifting and height adjusting knob Left side skirt Right side skirt Front skirt Rear skirt Debris container Debris container hook Debris container handle 20. Manual filter shaker handle Main broom movable lid Main broom height left adjuster Main broom height right adjuster Main broom right lid Main broom right lid mounting screws Pedal brake on front wheel (optional) Front skirt lifting lever Fuel tank cap Engine pull-start cord handle Fuel tap and engine choke lever compartment Engine exhaust pipe Engine ventilation grid Serial number plate/technical data/conformity certification Engine model Engine serial number Hood (open) Petrol engine Spark plug Choke lever Fuel tap Fuel tank Fuel tank cap Air filter Throttle lever (adjusted by the Manufacturer: do not tamper with it nor use it to change the engine speed!) Engine pull-start cord handle Engine oil filler/level check plug Engine oil drain plug Engine belt 57. Main broom belt Driving belt Side broom belt Petrol engine drive pulley Main broom drive pulley Drive system drive pulley Side broom drive pulley Vacuum fan Engine silencer Hood safety switch Position "0": The machine is off and all functions are disabled · In addition to the standard components, the machine can be equipped with the following accessories/options, according to the machine specific use: ­ Main and side brooms with harder or softer bristles ­ Antistatic polyester or polyester BIA C dust filter ­ Front wheel with pedal brake ­ Skirts of various materials For further information concerning the optional accessories, contact an authorised Retailer. General Machine length Machine width (without side brooms) Machine height (with lowered handlebar) Minimum/maximum handlebar height Cleaning width (without side broom) Cleaning width (with side broom) Minimum distance from the ground (skirts not included) Main broom size (diameter x length) Side broom diameter Main broom speed Side broom speed Front steering wheel Rear driving wheel (diameter x width) Machine total weight Debris container capacity Sound pressure level at workstation (A Lpa) Vibration level at the operator's arms (*) Values 1, 070 mm 773 mm 836 mm 824/1, 120 mm 600 mm 791 mm 40 mm 265 mm x 600 mm 420 mm 400 rpm 52 rpm 125/37. Under normal working conditions, on a level asphalt surface. Performance Maximum forward speed Gradeability Dust vacuuming and filtering Paper dust filter 5-10 m Main broom compartment vacuum Petrol engine (*) Make Model For other petrol engine data/values, see the relevant Manual. On some points of the machine there are some adhesive plates indicating: ­ DANGER ­ WARNING ­ CAUTION ­ CONSULTATION While reading this Manual, the operator must pay careful attention to the symbols shown on the plates. Do not cover these plates for any reason and immediately replace them if they are damaged. Make sure that the debris container (17) is properly closed before starting the machine. Do not fill the fuel tank beyond the upper limit mark (A, Fig. 2) by introducing the hand into the compartment (30) without opening the hood (7). nOTE Repeat the filter shaking procedure at least every 10 minutes. This interval can change depending on the dustiness of the area to be cleaned. Do not work on wet floors to prevent the dust filter from being damaged. The debris container (17) should be emptied after each working cycle and whenever it is full. The engine is equipped with a warning system to prevent damages to the engine itself in case the oil quantity in the carter is insufficient. Before the oil level goes below the safety limit, the warning system automatically stops the engine. [. . . ] The use of inadequate detergents can damage the filter. If necessary, clean the filter compartment rubber gasket (D, Fig. 14) turned towards the machine front side. Make sure that the machine cannot move independently; if equipped, press the pedal brake (26). [. . . ]