User manual NILFISK UZ 878B

[. . . ] Turn off all controls before unplugging. â· Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. â· Keep hair, loose clothing, fingers and all parts of the body away from openings and moving parts. Do not put any objects into openings or use with opening blocked. [. . . ] A double insulated appliance is marked with the words "DOUBLE INSULATION" or "DOUBLE INSULATED. " The symbol (square within a square) may also be used on the product. Noise level according to BS GD 930 GD 930 S2 reduced speed GD 930 S2 full speed 5415: 53 dB(A) 45 dB(A) 53 dB(A) Noise level with the nozzle against the floor according to IEC 704: UZ 930 S 76 dB(A) UZ 930 S2 reduced speed 71 dB(A) UZ 930 S2 full speed 76 dB(A) Specifications and details are subject to change without prior notice. The accessories shown in the pictures may vary from model to model. This appliance conforms with EC-Directive 89/336/EEC, EEC, 93/31/EEC, 73/23/EEC, 93/68/EEC. Power is supplied to the socket when the machine is switched on. Fit the opening on the dust bag over the air inlet. press the membrane over the flanged edge on the inlet. Push the hose coupling all the way in and turn clockwise. To reach them lift out the filter holder(a). Instead of these two filters you can fit a micro filter of HEPA-quality (e), wich traps 99, 99% of all particles larger than 0, 3 microns. The MACHINE OPERATOR must be trained by a suitably qualified instructor, and be made aware of the relevant regulations and legislation currently in force at the time of use. CAUTION - This machine MUST NOT be used in explosive or inflammable atmospheres or where such atmospheres are likely to be produced by the presence of volatile liquid or inflammable gas or vapour. CAUTION - In no circumstances should the power supply cord be wrapped around fingers or any part of the operators person. CAUTION - The electrical supply plug must not be subjected to undue stress by pulling on the power supply cord. Your MACHINE must only be connected to an electrical supply of the same voltage and frequency as indicated on the rating plate. Ensure that the plug fitted to the end of the power supply cord is suitable for your supply socket, if not refer to the information contained in 'Electrical Connections', or consult a qualified electrician. The electrical installation from which the supply is drawn must be maintained to current Institute of Electrical Engineers wiring regulations. REGULAR SERVICING and INSPECTION of your machine must be carried out by suitably qualified personnel in accordance with relevant legislation and regulations. In particular, electrical tests for earth continuity, insulation resistance, and condition of the flexible cord should be checked frequently. In the event of any defect the machine MUST be withdrawn from service, completely checked and repaired. Trained Service Engineers will be pleased to carry out on site servicing on a regular or as requested basis, to ensure the continuing safety and efficiency of your machine. [. . . ] If the available socket outlet is not suitable for the plug supplied, the plug must be cut off and an appropriate plug fitted. The plug thus cut off MUST BE DESTROYED for safety reasons before being disposed of. Machines built for other voltages and frequencies are not normally supplied with a fitted plug. If it is necessary to fit a plug, the wires in this power supply cord are coloured in accordance with the following code: To connect the new plug: The wire which is coloured green & yellow must be connected to the terminal in the plug which is marked with the letter 'E' or by the safety earth symbol or coloured green or green & yellow. [. . . ]