User manual NILFISK UZ 930S2

[. . . ] Should damage occur to electrical or mechanical parts, the cleaner and / or accessory should be repaired by the manufacturer or competent service station before use in order to avoid further damage to the machine or physical injury to the user. Disconnect the cleaner before servicing and when not in use. to unplug grasp the plug , not the cord. Do not handle plug or cleaner with wet hands. [. . . ] This filter should also be inspected and replaced if necessary. Standard: Fit the sections together and twist to lock in place. Telescopic: Push down the catch and then adjust the length. The accessories shown in the pictures may vary from model to model. A-b)Combination nozzle Adjust the nozzle according to the requirements of the floor you are cleaning. Work with the brush on hard floors and without it on soft floors. c)Universal nozzle for both hard floors and carpets. D)Crevice nozzle Use to clean furniture, radiators and others hard-to-reach places. E)Small combi-nozzle: The small combi-nozzle combines a dusting brush for furniture, picture frames, mouldings etc. With a fold-out nozzle for cleaning curtains, furniture and other soft surfaces. The clip on the hose handle holds the nozzle when it is not in use. G)Carpet nozzle with thread pick-up To use the thread pick-up, turn the nozzle. The UZ 930S/S2 is equipped with a specially designed cable, which if damaged, must be replaced by a cable of the same type. These cables are avaible at authorized service shops and must be installed by trained personnel. The UZ 930S/S2 is equipped with a thermal cut-out to protect the motor and other vital machine parts from overheating. Should the machine cut out, you will have to wait at least 5-10 minutes for it to automatically reset. While you are waiting, switch the machine off and unplug it, then check the hose, dust bag and filters to be sure that nothing is blocking the flow of air through the machine. Remove the plug from the socket before performing service or maintenance. The suction control in the hose handle lets you regulate the air-flow to prevent the nozzles from fastening to the surfaces you are vacuum cleaning. UZ 930S/S2 are designed, developed and rigorously tested to function efficiently and safely when properly maintained and used in accordance with the following instructions. [. . . ] The wire which is coloured blue must be connected to the terminal in the plug which is marked with the letter 'N' or is coloured black or blue. The wire which is coloured brown must be connected to the terminal in the plug which is marked with the letter 'L' or is coloured red or brown. If the plug to be fitted does not conform to the above notation then consult a qualified electrician. To connect the new plug: If using a three-pin plug, do not make any connection to the the terminal in the plug which is marked with the letter `E' or by the safety earth symbol or coloured green or green & yellow. [. . . ]