User manual NILFISK VC300 ECO

[. . . ] Before using the vacuum cleaner, the operators must be informed, instructed and trained on how to work it and for which substances its usage is permitted including the safe method for removing and disposing of the vacuumed material. The use of vacuum cleaner by people (including children) with limited physical and mental capacities or lacking in experience and knowledge is strictly forbidden, unless they are supervised by a person who is experienced in the use and safe handling of the machine. Children must be supervised to make sure they will not play with the machine. This vacuum cleaner is suitable for commercial use, in hotels, schools, hospitals, factories, shops, offices and apartment hotels for example, for hire and in any case for purposes other than normal domestic use. [. . . ] The plugs and connectors of the connection cables must be protected against splashes of water. check that for proper connection to the electrical mains. Use the vacuum cleaners only when the cables that connect to the electrical mains are in perfect condition (damaged cables could lead to electric shocks!Regularly check there are no signs of damage, excessive wear, cracks or ageing on the electric cable. Use only supplied and authorised genuine spare parts. When the vacuum cleaner is operating, do not: Crush, pull, damage or tread on the cable that connects to the electrical mains. Only disconnect the cable from the electrical mains by removing the plug (do not pull the cable). Only replace the electric power cable with one of the same type as the original: H07 RN - F. the same rule applies if an extension is used. The cable must be replaced by the manufacturer's Service Centre staff or by equivalent qualified personnel. Comply with the safety regulations governing the materials for which the vacuum cleaner is used. Clean the grill inside the container to remove debris or solid residues which may prevent the liquid from draining properly. Make sure the seal is in perfect condition and correctly positioned. Lock the castor brakes before starting the vacuum cleaner (1). Turn the switch to "0" position to turn the vacuum cleaner off. turn the switch (3) to "I" position to start the vacuum cleaner. Turn the switch to "0" position to turn the vacuum cleaner off. If the vacuum cleaner expels the air from the vacuum hose, the rotation direction is not correct; remove the plug from the socket and turn the selector inside the plug to perform the correct phase connection. Tilting discharge device assembly Fasten the hopper to the filtering chamber, by inserting it into the relevant housings and, operating on the lever (2) to lock it (figure 9). Insert the bag (Longopac®) into the relevant support and fasten its end with the belt (1, figure 10). Engage the tilting discharge device support to the hopper by fastening it with the relevant pins (figure 9). Remove the bag (Longopac®) until it lays on the lower support platform and close its end with the supplied clamp. [. . . ] Use the band (2) to remove the cover (3) together with the filter. Fit the new filter and secure it in the cage with special clamps. Install the cover and the filter in the reverse order of removal. Dispose of the old filter according to the laws in force. [. . . ]