User manual NISSAN SENTRA-2006

[. . . ] FOREWORD Welcome to the growing family of new NISSAN owners. This vehicle is delivered to you with confidence. It was produced using the latest techniques and strict quality control. This manual was prepared to help you understand the operation and maintenance of your vehicle so that you may enjoy many miles (kilometers) of driving pleasure. [. . . ] D (Drive): Use this position for all normal forward driving. 2 (Second gear): Use this position for hill climbing or engine braking on downhill grades. QR25DE: Do not shift into the 2 position at speeds above 62 MPH (100 km/h). Do not exceed 62 MPH (100 km/h) in the 2 position. QG18DE: Do not shift into the 2 position at speeds above 68 MPH (110 km/h). Do not exceed 68 MPH (110 km/h) in the 2 position. 1 (Low gear): Use this position when climbing steep hills slowly or driving slowing through deep snow, sand or mud, or for maximum engine braking on steep downhill grades. QR25DE: Do not shift into the 1 position at speeds above 34 MPH (55 km/h). Do not exceed 34 MPH (55 km/h) in the 1 position. QR18DE: Do not shift into the 1 position at speeds above 37 MPH (60 km/h). Do not exceed 37 MPH (60 km/h) in the 1 position. WSD0044 CAUTION Use this position only when the vehicle is completely stopped. Make sure the vehicle is completely stopped before selecting R (Reverse) position. The brake pedal must be depressed and the selector lever button pushed in to move the selector lever from P (Park), N (Neutral) or any drive position to R (Reverse). N (Neutral): Neither forward nor reverse gear is engaged. The engine can be started in this position. You may Starting and driving 5-9 Shift lock release If the battery is discharged, the shift selector lever may not be moved from the P (Park) position even with the brake pedal depressed and the shift selector lever button pushed. To move the shift selector lever, release the shift lock and push the shift selector lever button. The shift selector lever can be moved to N (Neutral). However, the steering wheel will be locked unless the ignition switch is turned to the ON position. To release the shift lock, complete the following procedure: 1. Turn the ignition key to the LOCK position and remove the key. Insert a small screwdriver in the shift lock slot, and push down B . [. . . ] . 5-10 Travel (See registering your vehicle in another country) . Trunk access through the rear seat Trunk lid lock opener lever . . 3-9 . 2-30 . 2-19 Uniform tire quality grading. . 9-9 Vehicle identification number (VIN) (Chassis number). [. . . ]