User manual NISSAN Z COUPE 2008

[. . . ] Foreword Welcome to the growing family of new NISSAN owners. This vehicle is delivered to you with confidence. It was produced using the latest techniques and strict quality control. This manual was prepared to help you understand the operation and maintenance of your vehicle so that you may enjoy many miles of driving pleasure. [. . . ] A tone sounds and the system announces "Memo recorded. " Another tone sounds to end the VR session. If the memo pad is full, the system asks if you wish to record over the oldest memo. C "Delete" k Use the Delete command to erase one entry from the phone book, all entries from the phone book, the current redial number or the current call back number. To delete entries from the phone book, say a name or "All entries" when prompted by the system. The system acknowledges the command and asks you to confirm the deletion. To delete the current redial number or call back number, say "redial number" or "call back number" when prompted by the system. If a redial number or a call back number exists, "Memo pad" The Delete command erases all memos. The system asks you to confirm this action before deleting all memos. The Memo Pad records a maximum of 6 voice memos, each up to 20 seconds long. 4-40 Display screen, heater, air conditioner and audio systems "Setup" must first delete one phone or replace an existing phone. If you try to pair a phone that has already been paired to your vehicle's system, the system announces the name the phone is already using. The pairing procedure will then be cancelled. When prompted by the system, choose from the following commands: ¼ "New phone" -- Refer to "Pairing a phone" earlier in this section. ¼ "Replace phone" -- The system announces the names of the phones already paired and asks which you would like to replace. Once you say the name of the phone you wish to replace, the paring procedure will begin. Refer to "Pairing procedure" earlier in this section. ¼ "List phones" -- See the description below. B "List phones" k phone of lesser priority when two or more phones paired with Bluetooth Hands-Free Phone System are in the vehicle at the same time. The system asks you to name the phone and confirm the selection. Once the selection is confirmed, the selected phone remains active until the ignition switch is turned OFF or you select a new phone. D "Change priority" k Use the Change Priority command to change the priority level of the active phone. The priority level determines which phone is active when more than one paired Bluetooth phone is in the vehicle. The system states the priority level of the active phone and asks for a new priority level (1, 2, 3, 4, 5). If the new priority level is already being used for another phone, the two phones will swap priority levels. For example, if the current priority levels are: Priority Level 1 = Phone A Priority Level 2 = Phone B Priority Level 3 = Phone C Use the Setup command to change options associated with the Bluetooth Hands-Free Phone System. A "Pair phone" k Use the Pair Phone command to pair a phone to the Bluetooth Hands-Free Phone System. When you are asked to enter a PIN code for pairing your Bluetooth cellular phone, operate it to enter the code "1234". [. . . ] 7-3 Power windows. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-39 Windshield wiper and washer switch. . . . . . . . . . . . . . . . . . 2-21 Wiper Rear window wiper and washer switch. . . . . . . . 2-22 Windshield wiper and washer switch . . . . . . . . . . . [. . . ]