User manual NITECORE MH1A

[. . . ] ® ALL-ROUND Flashlight Expert User Manual Charging indicator light 1. Connect the charging cable to the flashlight and the A/C power adapter to the wall outlet as shown in the adjacent image. Fully charging a depleted 14500 battery takes approximately 2 hours. [. . . ] Turbo provides 100% output while user-defined contains five selectable sub-modes. SIZE Nominal voltage Compatible Yes (Compatible and can be recharged) Yes (Compatible but can NOT be recharged) Yes (Compatible but can NOT be recharged) Yes (Compatible but can NOT be recharged) Yes (Compatible but can NOT be recharged) 14500 AA AA L91 14500 3. 7V 1. 5V 1. 2V 1. 5V 3. 2V Turbo mode provides an output of 550 lumens and is accessed when the flashlight is switched ON with the head lightly tightened. While in this mode, momentary illumination can be achieved by switching off the flashlight and then half pressing and holding the switch. Note: After three minutes of use in turbo mode, the flashlight will lower its output automatically to preventing overheating and increase runtime. *Warning: Charge 14500 rechargeable Li-ion batteries only, do not attempt to charge non-rechargeable batteries, i. e. AA batteries. User-Defined Mode Brightness & Runtime TURBO HIGH MID LOW NOTICE User-defined mode is accessed by slightly loosening the flashlight head. In this mode, lightly and rapidly pressing the switch will cycle through brightness and other functions in the following order: “High-Mid-Low-SOS-Strobe”. Pressing the switch all the way down will save and memorize a desired setting. LUMENS 550 LUMENS 81 4h LUMENS 18 LUMENS 7 45min 11h30min 23h 125m (Beam Distance) 3800cd (Peak Beam Intensity) 1. 5m (Impact Resistant) IPX-8, 2m (Waterproof AND Submersible) Stated data has been measured according to the international flashlight testing standards ANSI/NEMA FL1 using one NITECORE 14500 battery (3. 7V, 750mAh) under laboratory conditions. The data may vary due to individual usage habits and environmental conditions. Tips: Make NITECORE MH1A your perfect Multitask Hybrid flashlight. NITECORE MH1A flashlights essentially have two modes: Turbo mode (100% output) and custom mode. Turbo mode is accessed by tightening the flashlight head while any of the five customizable modes (strobe, SOS, low, medium and high) are selected by loosening the head and rapidly pressing the on/off switch to cycle through the modes. A given mode can be saved by simply turn off the light while in that mode. Real-world examples include: When used as a flashlight around the home, the head can be loosened and low level selected in custom mode, providing long runtimes at a lower light intensity. The same flashlight could then be taken out and used a law-enforcement duty light, with user-defined mode set in strobe, making it easy to alternate between turbo mode and strobe with a simple twist of the flashlight head. Maintenance NITECORE (SYSMAX) is a member of PLATO, participating in and helping to develop the ANSI FL1 standard of measurement. Product testing data is in accordance with these internationally recognized scientific standards. Every 6 months, threads should be wiped with a clean cloth followed by a thin coating of silicon-based lubricant. Warranty Service Operation instructions 1. Unscrew the tail cap in a counter-clockwise direction. Insert one 14500 battery with the positive pole pointing forward (toward the light head). Battery installation (see adjacent diagram) NOTE: Ensure batteries are inserted with the positive (+) end pointing to the head. The MH1A will not operate with incorrectly inserted batteries. All NITECORE® products are warranted for quality. [. . . ] The product(s) is/are damaged by leakage of batteries. For the latest information on NITECORE® products and services, please contact your national NITECORE® distributor or send an email to service@nitecore. com Charging Function The MH1A is capable of charging a protected 14500 Li-ion battery via the included USB cable. Simply install a protected 14500 Li-ion cell, plugging one end of the USB cable into the flashlight and the other end into a universal USB port / adaptor and the MH1A will take care of the rest. SYSMAX Industry Co. , Ltd. Please follow our facebook for more info: NITECORE Flashlights TEL: +86-20-83862000 FAX: +86-20-83882723 E-mail: info@nitecore. com Web: www. nitecore. com Address： Rm1407-08, Glorious Tower, 850 East Dongfeng Road, Guangzhou, China 510600 Thanks for purchasing NITECORE! [. . . ]