User manual NOKIA 3586I

[. . . ] User Guide Nokia 3586i User Guide What information is needed?My number Voice mail number Wireless provider's number Provider's customer care Model number Phone type Electronic serial number (ESN) Numbers Where is the number?Wireless service provider Wireless service provider Wireless service provider Wireless service provider Nokia 3586i RH-44 See "About your phone" on page 11. See "Your phone's label" on page 9. [. . . ] When you receive an incoming call, your phone displays the caller's phone number (or the caller's entry in your phone book). The phone also beeps, notifying you of the incoming call. Answering a waiting call Press the Send key (or press Answer) to place the current active call on hold automatically and answer the new call. Switch between the two calls Accepting the waiting call puts the your first caller on hold. To put the second caller on hold and reconnect with the first caller, press the Send key. End the active call To end the active call, simply allow the other party to hang up; the call on hold then becomes the active call. OR: 1 2 Press the End key to terminate the active call. The network redials your phone with the call on hold. Answer this as you would any normal incoming call. · MAKE A CONFERENCE CALL This feature allows you to talk to two people at the same time. Conference calling is a network-dependent feature. [ 85 ] Note: Check with your service provider to make sure this service is available in your network. 1 2 3 4 5 Make a call to the first participant as usual. When you are ready to place a call to the next party: Press Options, then press New call. Enter the number and press the Send key (or press Search to recall the number from the phone book). Press the Send key again to connect both parties. This action disconnects both parties. End calls To end a conference call (disconnect with all callers), press the End key. Or you can also press Options, then select End all calls. Disconnect second party While all three parties are connected, pressing the Send key disconnects the second caller, keeping the first party's call active. Disconnect first party If you wish to disconnect with the first party and remain connected to the second party, have the first party terminate the call on his/her end. · SEND OWN CALLER ID WHEN CALLING This feature allows you to block caller ID when you call someone (your number will not be displayed on their caller ID). This feature may only be effective when calling a number equipped with caller ID. Note: This feature is available only when supported by the wireless network and may not function if you are roaming. Important: This feature works on a call-by-call basis. You must enable this feature each time you want to block the sending of your own number to the recipient's caller ID. [ 86 ] Advanced features Store the feature codes Before you can use the Send own caller ID when calling feature, you must store the feature codes for activating this feature. Once the code is stored in your phone, it is sent automatically to the network when you select this option from your phone's menu. 1 2 3 Press Menu 4-7-5 (Settings > Network services > Network feature setting). The Feature code field appears after a few seconds. Enter the feature code your service provider gave you (example *67 for activating Send own caller ID when calling), then press OK. [. . . ] Try to plan your calls before you begin your trip or attempt to coincide your calls with times you may be stopped at a stop sign, red light or otherwise stationary. But if you need to dial while driving, follow this simple tip--dial only a few numbers, check the road and your mirrors, then continue. 7 Do not engage in stressful or emotional conversations that may be distracting. Stressful or emotional conversations and driving do not mix--they are distracting and even dangerous when you are behind the wheel of a car. [. . . ]