User manual NOKIA BH-102

[. . . ] Nokia reserves the right to revise this document or withdraw it at any time without prior notice. The availability of particular products may vary by region. Please check with your Nokia dealer for details. 2 © 2008 Nokia. All rights reserved. Export controls This device may contain commodities, technology or software subject to export laws and regulations from the US and other countries. [. . . ] Enter the passcode 0000 to the indicator light is displayed. The pair and connect the headset to headset tries to connect to a your phone. you may need to make the © 2008 Nokia. Charging the battery fully may take up to 2 hours. When the battery is fully charged, the indicator light turns off. Disconnect the charger from the headset and the wall outlet. The fully charged battery has power for up to 10 hours of talk time or up to 250 hours of standby time. When battery power is low, the headset beeps once every minute and the indicator light flashes quickly. To switch off, press and hold the multifunction key for about 4 to 8 seconds. Pair the headset 5 connection separately after pairing. You only need to pair the headset with your phone once. If the pairing is successful, the headset appears in the phone menu where you can view the currently paired Bluetooth devices. When the headset is connected to your phone and is ready for use, the indicator light flashes slowly. Basic use Put on the headset To use the headset on your right ear, attach the earloop as shown in Figure 7; to use the headset on your left ear, attach the earloop from the other side. Slide the earloop over your ear (9), and gently push the earpiece into your ear. Point the headset towards your mouth (10). Call handling To make a call, use your phone in the normal way when the headset is connected to your phone. To redial the number you last called (if your phone supports this feature with the headset), when no call is in progress, press the multifunction key twice. To activate voice dialling (if your phone supports this feature with the headset), when no call is in progress, press and hold the 6 © 2008 Nokia. All rights reserved. multifunction key for about 2 to 4 seconds. Proceed as described in the phone user guide. To answer or end a call, press the multifunction key. To adjust the volume during a call, use the phone volume keys. To switch a call between the headset and a compatible phone, press and hold the multifunction key for about 2 to 4 seconds. and press and hold the multifunction key for over 8 seconds until the headset beeps twice and the indicator light flashes quickly. To reset the headset if it stops functioning, even though it is charged, plug the headset into a charger. Troubleshooting If you cannot connect the headset to your compatible phone, check that the headset is charged, switched on, and paired with your phone. Clear settings or reset To delete the pairings from the headset, switch off the headset, Battery information This device has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the device as you may damage the device. [. . . ] High temperatures can shorten the life of electronic devices, damage batteries, and warp or melt certain plastics. · Do not store the device in cold areas. When the device returns to its normal temperature, moisture can form inside the device and damage electronic circuit boards. · Do not attempt to open the device. [. . . ]