User manual NOKIA BH-606

[. . . ] Nokia reserves the right to revise this document or withdraw it at any time without prior notice. The availability of particular products may vary by region. Please check with your Nokia dealer for details. 2 © 2008 Nokia. All rights reserved. Export controls This device may contain commodities, technology or software subject to export laws and regulations from the US and other countries. [. . . ] The headset tries to connect to a paired phone. To switch off, press and hold the power key for about 2 seconds. The headset beeps, and the indicator light turns off. Pair the headset 5 you may need to make the connection separately after pairing. When the headset is connected to your phone and is ready for use, the indicator light flashes about every 5 seconds. Basic use Place the headset on the ear Slide the earloop behind your ear, and point the headset toward your mouth (9 and 10). To use the headset on the left ear, detach the earloop (11), flip it, and push it into place (12). no call is in progress, press the answer/end key twice. To activate voice dialling (if your phone supports this feature with the headset), when no call is in progress, press and hold the answer/end key for about 2 seconds. Proceed as described in the phone user guide. To answer or end a call, press the answer/end key. To set the headset volume, slide the volume key up or down. Calls To make a call, use your phone in the normal way when the headset is connected to it. To redial the number you last called (if your phone supports this feature with the headset), when 6 © 2008 Nokia. All rights reserved. To mute or unmute the microphone during a call, press the middle of the volume key. To switch a call between the headset and a compatible phone, press and hold the answer/end key (or the power key) for about 2 seconds. hold the answer/end key for about 2 seconds. To use these features, your phone must support the Bluetooth Hands-Free profile 1. 5, and call waiting (network service) must be activated in the phone. Clear settings or reset To delete the pairings from the headset, switch off the headset, and press and hold the power key and the answer/end key for about 5 seconds. To reset the headset if it stops functioning, even though it is charged, connect the headset to a charger that is connected to a wall outlet. Handle two calls To answer a waiting call and put the active call on hold, press and hold the answer/end key for about 2 seconds. To answer a waiting call and end the active call, press the answer/ end key. To end the active call and activate the call on hold, press the answer/ end key. To switch between the active call and the call on hold, press and Troubleshooting If you cannot connect the headset to your compatible phone, check that the headset is charged, 7 © 2008 Nokia. All rights reserved. switched on, and paired with the phone. Battery and charger information This device has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the device as you may damage the device. This device is intended for use when supplied with power from the following chargers: AC-3, AC-4, AC-5, and DC-4. The exact charger model number may vary depending on the type of plug. The plug variant is identified by one of the following: E, EB, X, AR, U, A, C, or UB. [. . . ] · Do not store the device in cold areas. When the device returns to 10 its normal temperature, moisture can form inside the device and damage electronic circuit boards. · Do not attempt to open the device. · Do not drop, knock, or shake the device. [. . . ]