User manual NOKIA BICYCLE CHARGER DC-14

[. . . ] Read this guide carefully before installing and using the product. Also, read the user guide for your bicycle and the Nokia device that you connect to the charger. Keep them out of the reach of small children. Warning: The connectors of this device may contain a small amount of nickel. [. . . ] Position the bracket is firmly attached to the dynamo correctly using the dynamo. Attach the bracket to the To detach the roller from the tyre, pull front fork the dynamo away from the tyre (17). To attach the mounting bracket to the Attach the electric wire right side of the front fork on your To attach the electric wire to the bicycle, use the supplied bolts, nuts, and screw (13). Make sure the bracket dynamo, firmly press and hold the latch at the bottom of the dynamo is firmly attached to the fork. upwards (18), guide the bare end of the wire through the hole (19), and release the latch to lock the wire in place. Attach the dynamo to the mounting bracket ENGLISH Attach the grounding wire To attach the grounding wire to the mounting bracket, place the connector of the wire under the nut (20), and tighten the bolt to lock the wire firmly in place. Mount the charger and mobile device Attach the charger to the handlebar To attach the charger and your Nokia mobile device to the handlebar, use the supplied Nokia Phone Holder for Bicycles CR-124. Place the holder on the top and the charger on the bottom of the handlebar (21). Thread the straps of the holder through the slots at the charger (22). of the corresponding cables and wires into each other (23). Attach the electric and grounding wires to the head tube with the supplied removable cable ties. Make sure the charger is properly mounted (24). Attach the mobile device to the handlebar Place the mobile device over the holder. Carefully stretch the holder straps, and thread them around the top and rear sides of the mobile device (25). Make sure the mobile device stays firmly in place and is properly mounted (26). Connect the cables To connect the charger cables to the electric wire attached to the dynamo and the grounding wire attached to the mounting bracket, press the ends ENGLISH To keep the holder attached to the handlebar when you are not using it, carefully stretch the holder straps over the handlebar, and thread the straps behind the tabs on the charger (27). Make sure the holder stays firmly in place (28). Connect the charger to the mobile device Plug the charging cable of the charger into the 2. 0 mm charger connector on your Nokia device. If you connect the dynamo to a headlamp at the same time, your device will not charge properly. Charge the battery using the dynamo Make sure the charger is connected to your mobile device. Press the lever of the dynamo so that the friction roller touches the tyre. Begin pedalling your bicycle faster than 6 km/h (4 mph), which is a typical walking speed. If you pedal too slowly, charging may not start even when you increase your speed. In that case, stop the bicycle, and detach the charging cable from the mobile device for a few seconds. Take care of your device Handle your device and accessories with care. [. . . ] Check product environmental information and how to recycle your Nokia products at www. nokia. com/werecycle, or with a mobile device, www. nokia. mobi/ werecycle. The crossed-out wheeled-bin symbol on your product, battery, literature, or packaging reminds you that all electrical and electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life. This requirement applies in the European Union. [. . . ]