User manual NOKIA BLUETOOTH HEADSET BH-102

[. . . ] Diversion contrary to law is prohibited. © 2008 Nokia. Nokia and Nokia Connecting People are registered trademarks of Nokia Corporation. Other product and company names mentioned herein may be trademarks or tradenames of their respective owners. Reproduction, transfer, distribution, or storage of part or all of the contents in this document in any form without the prior written permission of Nokia is prohibited. [. . . ] Enter the passcode 0000 to pair and connect the headset to your phone. In some phones, you may need to make the connection separately after pairing. You only need to pair the headset with your phone once. If the pairing is successful, the headset appears in the phone menu where you can view the currently paired Bluetooth devices. When the headset is connected to your phone and is ready for use, the indicator light flashes slowly. Pair the headset 1. Ensure that your phone is switched on and the headset is switched off. Press and hold the multifunction key (for about 4 to 8 seconds) until the indicator light starts to flash quickly. Activate the Bluetooth feature on the phone, and set the phone to search for Bluetooth devices. Select the headset from the list of found devices. ENGLISH Basic use Put on the headset To use the headset on your right ear, attach the earloop as shown in Figure 7; to use the headset on your left ear, attach the earloop from the other side. Slide the earloop over your ear (9), and gently push the earpiece into your ear. Point the headset towards your mouth (10). headset), when no call is in progress, press and hold the multifunction key for about 2 to 4 seconds. Proceed as described in the phone user guide. To answer or end a call, press the multifunction key. To adjust the volume during a call, use the phone volume keys. To switch a call between the headset and a compatible phone, press and hold the multifunction key for about 2 to 4 seconds. Call handling To make a call, use your phone in the normal way when the headset is connected to your phone. To redial the number you last called (if your phone supports this feature with the headset), when no call is in progress, press the multifunction key twice. To activate voice dialling (if your phone supports this feature with the Clear settings or reset To delete the pairings from the headset, switch off the headset, and press and hold the multifunction key for over 8 seconds until the headset beeps twice and the indicator light flashes quickly. ENGLISH To reset the headset if it stops Troubleshooting functioning, even though it is charged, If you cannot connect the headset to plug the headset into a charger. your compatible phone, check that the headset is charged, switched on, and paired with your phone. Battery information This device has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the device as you may damage the device. The battery can be charged and discharged hundreds of times, but it will eventually wear out. Recharge your battery only with Nokia approved chargers designated for this device. [. . . ] · Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device. Paint can clog the moving parts and prevent proper operation. If the device is not working properly, take it to the nearest authorised service facility for service. Disposal The crossed-out wheeled-bin symbol on your product, literature, or packaging reminds you that all electrical and electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life. [. . . ]