User manual NOKIA BLUETOOTH HEADSET BH-104

[. . . ] A copy of the Declaration of Conformity can be found at http://www. nokia. com/phones/ declaration_of_conformity/. © 2008-2009 Nokia. Nokia, Nokia Connecting People and the Nokia Original Accessories logo are trademarks or registered trademarks of Nokia Corporation. Nokia tune is a sound mark of Nokia Corporation. Other product ENGLISH contents of this document. [. . . ] Within about 3 minutes, activate key for about 2 seconds. The headset the Bluetooth feature on the beeps, and the green indicator light is phone, and set it to search for displayed. Select the headset from the list of To switch off, press and hold the found devices. power key for about 2 seconds when the headset is on. If necessary, enter the passcode 0000 to pair and connect the and the red indicator light is briefly headset to your phone. If the headset is not phones, you may need to make the ENGLISH connection separately after pairing. When the headset is connected to your phone and is ready for use, the green indicator light flashes about every 5 seconds. Basic use Place the headset on the ear The headset is ready to be used on the left ear. To use the headset on the right ear, rotate the earloop so that it is to the right of the Nokia logo (11 and 12). Slide the earloop behind your ear (9), and gently push the earpiece against your ear. Carefully bend the earloop around your ear for the best fit. Push or pull the earloop to set its length. Point the headset towards your mouth (10). Calls To make a call, use your phone in the normal way when the headset is connected to it. To redial the number you last called (if your phone supports this feature with the headset), when no call is in progress, press the answer/end key twice. To activate voice dialling (if your phone supports this feature with the headset), when no call is in progress, press and hold the answer/end key for about 2 seconds. Proceed as described in the phone user guide. ENGLISH To answer or end a call, press the answer/end key. To adjust the volume, press either volume key. To mute or unmute the microphone, press both volume keys at the same time. When the microphone is muted, the green indicator light flashes twice about every 5 seconds. To switch a call from the headset to a compatible phone, press and hold the answer/end key for about 2 seconds, or switch off the headset. To switch the call back to the headset, press and hold the answer/end key for about 2 seconds, or switch on the headset. headset is connected to a phone) or back on, press and hold the power key and the answer/end key for about 5 seconds when the headset is connected to a phone. Clear settings or reset To delete the pairings from the headset when it is switched off, press and hold the power key and the answer/end key (for about 5 seconds) until the red and green indicator lights start to alternate. To reset the headset if it stops functioning, even though it is charged, connect the headset to a charger while you press and hold the power key. Turn lights on or off By default, the indicator lights are shown in all situations. [. . . ] These suggestions apply equally to your device, charger, or any accessory. If any device is not working properly, take it to the nearest authorised service facility for service. Recycle The crossed-out wheeled-bin symbol on your product, battery, literature, or packaging reminds you that all electrical and electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life. This requirement applies in the European Union. [. . . ]