User manual NOKIA BLUETOOTH HEADSET BH-217

[. . . ] Nokia Bluetooth Headset BH-217 1 3 2 5 8 6 4 7 Issue 1 10 9 12 13 11 14 ENGLISH DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION declares that this BH-217 product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www. nokia. com/phones/ declaration_of_conformity/. the products described in this document without prior notice. Bluetooth is a registered trademark of Bluetooth SIG, Inc. [. . . ] If necessary, enter the passcode 0000 to pair and connect the headset to your device. In some devices, you may need to make the connection separately after pairing. Pair and connect the headset Before using the headset, you must pair and connect it to a compatible device. You can pair the headset with up to eight devices, but you can connect it to a maximum of two devices at a time. To pair and connect the headset to a device: 1. Make sure your mobile device is switched on and the headset is off. If the headset has not been previously paired with a device, switch on the headset. The headset enters pairing mode, and the blue indicator light starts to flash quickly. ENGLISH When the headset is connected to at least one device and is ready for use, the blue indicator light flashes slowly. To manually connect the headset to the last used device, press and hold the multifunction key for about 2 seconds (when no other device is connected), or make the connection in the Bluetooth menu of the device. You may be able to set your device so that the headset connects to it automatically. To activate this feature in a Nokia device, modify the paired device settings in the Bluetooth menu. Basic use Change the earpad The headset may be provided with different sized earpads. Select the earpad that fits the best and is the most comfortable for your ear. To change the earpad, pull the current earpad from the earpiece, and push the new earpad into place (7). the earloop, gently pull it from the headset. You can rotate the earpad to keep the headset securely in the ear (8). For example, if you use the headset on the right ear, you may need to rotate the earpad to the right for the best fit. If you wear an earring, make sure it is not accidentally attached to the earpad. To place the headset on the ear, slide the earloop behind your ear (9), and gently push the earpiece against your Place the headset on the ear To use the headset with the earloop, attach the earloop to it (11). Point the headset towards your mouth (10). the airbag is not blocked or impaired in any way. To install the car cradle, peel off the protective sheet from the cradle, and press the cradle against a flat surface so that it stays firmly in place. Do not install the cradle in a place where you might come in contact with it in the event of an accident or collision. Store in the clip or car cradle When you do not keep the headset on your ear, store it in the clip or car cradle. When the headset is in the clip or cradle, it is switched off. [. . . ] Use the charger for its intended purpose only. Improper use or use of unapproved chargers may present a risk of fire, explosion, or other hazard, and may invalidate any approval or warranty. If you believe the charger is damaged, take it to a service centre for inspection before continuing to use it. Only use the charger indoors. Take care of your device Handle your device, charger and accessories with care. [. . . ]