User manual NOKIA BLUETOOTH HEADSET BH-606

[. . . ] Nokia, Nokia Connecting People and the Nokia Original Accessories logo are trademarks or registered trademarks of Nokia Corporation. Other product and company names mentioned herein may be trademarks or tradenames of their respective owners. Reproduction, transfer, distribution, or storage of part or all of the contents in this document in any form without the prior written permission of Nokia is prohibited. Bluetooth is a registered trademark of Bluetooth SIG, Inc. [. . . ] To switch off, press and hold the power key for about 2 seconds. Enter the passcode 0000 to pair headset beeps, and the indicator light and connect the headset to your turns off. In some phones, you may need to make the connection Pair the headset separately after pairing. Ensure that your phone is on and When the headset is connected to the headset is off. Press and hold the power key (for indicator light flashes about every 5 about 5 seconds) until the seconds. Basic use Place the headset on the ear Slide the earloop behind your ear, and point the headset toward your mouth (9 and 10). To use the headset on ENGLISH the left ear, detach the earloop (11), flip it, and push it into place (12). To mute or unmute the microphone during a call, press the middle of the volume key. To switch a call between the headset and a compatible phone, press and hold the answer/end key (or the power key) for about 2 seconds. Calls To make a call, use your phone in the normal way when the headset is connected to it. To redial the number you last called (if your phone supports this feature with the headset), when no call is in progress, press the answer/end key twice. To activate voice dialling (if your phone supports this feature with the headset), when no call is in progress, press and hold the answer/end key for about 2 seconds. Proceed as described in the phone user guide. To answer or end a call, press the answer/end key. To set the headset volume, slide the volume key up or down. Clear settings or reset To delete the pairings from the headset, switch off the headset, and press and hold the power key and the answer/end key for about 5 seconds. To reset the headset if it stops functioning, even though it is charged, connect the headset to a charger that is connected to a wall outlet. Troubleshooting If you cannot connect the headset to your compatible phone, check that the headset is charged, switched on, and paired with the phone. ENGLISH Battery and charger information This device has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the device as you may damage the device. This device is intended for use when supplied with power from the following chargers: AC-3, AC-4, AC-5, and DC-4. The exact charger model number may vary depending on the type of plug. The plug variant is identified by one of the following: E, EB, X, AR, U, A, C, or UB. The battery can be charged and discharged hundreds of times, but it will eventually wear out. Recharge your battery only with Nokia approved chargers designated for this device. Use of an unapproved charger may present a risk of fire, explosion, leakage, or other hazard. If a battery is being used for the first time or if the battery has not been used for a prolonged period, it may be necessary to connect the charger, then disconnect and reconnect it to begin charging the battery. [. . . ] Paint can clog the moving parts and prevent proper operation. These suggestions apply equally to your device, charger, or any accessory. If any device is not working properly, take it to the nearest authorised service facility for service. Disposal The crossed-out wheeled-bin symbol on your product, literature, or packaging reminds you that all electrical and electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life. [. . . ]