User manual NOKIA BLUETOOTH SPEAKERS MD-7W

[. . . ] Export Controls This device may contain commodities, technology or software subject to export © 2007 Nokia. Nokia and Nokia Connecting People are registered trademarks of Nokia Corporation. Other product and company names mentioned herein may be trademarks or tradenames of their respective owners. Reproduction, transfer, distribution, or storage of part or all of the contents in this document in any form without the prior written permission of Nokia is prohibited. [. . . ] This device is intended for use when supplied with power from the AC-4 charger. Warning: Use only chargers approved by Nokia for use with this particular device. The use of any other types may invalidate any approval or warranty and may be dangerous. When you disconnect the power cord of any enhancement, grasp and pull the plug, not the cord. Connect to power The speakers can be powered by the supplied charger or four AA batteries. ENGLISH Connect to wall outlet To use the speakers with the charger, connect the charger to a wall outlet, and plug the charger cable to the power connector. If you use rechargeable batteries with the speakers, the batteries are not charged by the charger. Install AA batteries To install the batteries, ensure that the speakers are switched off, and press the release switch of the battery cover at the back of each speaker. Place the batteries as indicated in the compartment. To close the cover, insert the catch at the top of the cover into the corresponding slot on the speaker, and push the cover against the speaker until it snaps into place. During long periods where the speakers are not used, remove the batteries to prevent damage from battery leakage. When battery power is low, the orange indicator light starts to flash, and the speakers beep. Switch the speakers on or off To switch on, press and hold the power key until the white indicator light turns on. The orange indicator light is briefly displayed. Connect the speakers You can connect the speakers to a compatible music device (such as a music player or mobile phone with a music player feature) using Bluetooth wireless technology or the supplied cable. To use a Bluetooth connection, the music device must support the A2DP Bluetooth profile. ENGLISH Pair and connect using Bluetooth wireless technology The following instructions apply for a mobile phone but the procedure is the same for a music player, except that you may not need to give the Bluetooth passcode. Ensure that the speakers are off and that the phone is on. Press and hold the power key until the white indicator light starts to flash. Activate the Bluetooth feature on the phone, and set it to search for Bluetooth devices. Select the speakers from the list of found devices. Enter the Bluetooth passcode 0000 to pair and connect the speakers to the phone. In some phones you may need to make the connection separately after pairing. If the pairing is successful and the speakers are in a Bluetooth connection with the music device, the white indicator light flashes about every 4 seconds. Connect using a cable You can connect the speakers to a compatible device with the supplied CA-63U cable. To connect the speakers to a device that has a standard 3. 5 mm audio connector, plug the cable into the audio connector on the speakers and the other device. When the speakers are connected to the other device using the cable, the white indicator is continuously on. ENGLISH Basic use Listen to music When the speakers are connected to a compatible music device, start the music playback on the device. Warning: Listen to music at a moderate level. [. . . ] Rough handling can break internal circuit boards and fine mechanics. · Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device. Paint can clog the moving parts and prevent proper operation. If the product is not working properly, take it to the nearest authorised service facility for service. [. . . ]