User manual NOKIA HEADSET BH-202

[. . . ] Nokia reserves the right to revise this document or withdraw it at any time without prior notice. The availability of particular products may vary by region. Please check with the Nokia dealer nearest to you. Unauthorized changes or modifications to this device may void the user's authority to operate the equipment. 2 Introduction Export Controls This device may contain commodities, technology or software subject to export laws and regulations from the US and other countries. [. . . ] It may take a while before charging starts. If charging does not start, disconnect the charger, plug it in again, and retry. Charging the battery fully may take up to 2 hours 30 minutes. When the battery is fully charged, the indicator light turns off. Disconnect the charger from the headset and the wall outlet. The fully charged battery has power for up to 10 hours of talk-time or up to 200 hours of standby time. However, the talk and standby times may vary when used with different mobile phones or other compatible Bluetooth devices, usage settings, usage styles, and environments. When battery power is low, the indicator light flashes quickly. Switch the headset on or off To switch on, press and hold the multifunction key until the indicator light is displayed. To switch off, press and hold the multifunction key until the indicator light briefly flashes several times and turns off. Pair the headset 1. Ensure that your phone is switched on and that the headset is switched off. Press and hold the multifunction key (for about 8 seconds) until the indicator light is continuously displayed. Activate the Bluetooth feature on the phone, and set the phone to search for Bluetooth devices. Select the headset from the list of found devices. Enter the passcode 0000 to pair and connect the headset to your phone. In some phones you may need to make the connection separately after pairing. You only need to pair the headset with your phone once. If the pairing is successful, the indicator light briefly flashes five times, and the headset appears in the phone menu where you can view the currently paired Bluetooth devices. The headset is now ready for use. Basic use Wear the headset Slide the earloop behind your ear, and point the headset toward your mouth. To use the headset on the left ear, gently flip (8) and rotate the earloop (9). If your phone supports last number redialing with the headset, press and hold the multifunction key (when no call is in progress) until you hear a beep. If your phone supports voice dialing with the headset, briefly press the multifunction key when no call in progress, and proceed as described in the user guide of your phone. Call handling To make a call, use your phone in the normal way when the headset is connected to your phone. 6 Battery information To answer or end a call, briefly press the multifunction key. [. . . ] · Do not store the device in cold areas. When the device returns to its normal temperature, moisture can form inside the device and damage electronic circuit boards. · Do not attempt to open the device. · Do not drop, knock, or shake the device. [. . . ]