User manual NOKIA HEADSET BH-604

[. . . ] Nokia Bluetooth Stereo Headset BH-604 User Guide 9203660 Issue 2 EN DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION declares that this HS-96W product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www. nokia. com/phones/ declaration_of_conformity/. © 2007 Nokia. Reproduction, transfer, distribution or storage of part or all of the contents in this document in any form without the prior written permission of Nokia is prohibited. Nokia and Nokia Connecting People are registered trademarks of Nokia Corporation. [. . . ] Do not attempt to remove the battery from the headset, as you may damage the headset. Connect the charger cable to the charger connector. The indicator light is red while charging. It may take a while before charging starts. If charging does not start, disconnect the charger, plug it in again, and retry. Charging the battery fully takes less than 1 hour and 15 minutes. When the battery is fully charged, the indicator light turns green. Disconnect the charger from the headset and the wall outlet. The fully charged battery has power for up to 18 hours of talk time, up to 2 weeks of standby time, or up to 19 hours of music playing time. However, the times may vary with different compatible Bluetooth devices, usage settings, usage styles, and environments. When battery power is low, the headset beeps at regular intervals, and the indicator light slowly flashes red. Recharge the battery. Switch the headset on or off Switch on To switch on, press and hold the multifunction key for about 2 seconds. The headset beeps, and the green indicator light is briefly displayed. When the headset tries to connect to the paired mobile phone or music player that you have last used with it, the indicator light slowly flashes green. When the headset is connected to a paired device and is ready for use, the indicator light slowly flashes blue. If the headset has not been paired with a device, it automatically enters the pairing mode (see "Pair and connect the headset, " p. If you connect the headset to a device but do not use it for a while, switch off the headset to save power. Switch off To switch off, press and hold the multifunction key for about 5 seconds. The headset beeps, and the red indicator light is briefly displayed. 7 Get started Pair and connect the headset Pair and connect the headset with a mobile phone that has a music player feature If your phone supports the A2DP Bluetooth profile and has a music player feature, you can use the phone to make and receive calls and to play music with the headset. If the headset has not been previously paired with a device, switch on the headset. The headset enters the pairing mode, and the indicator light starts to flash blue quickly. If the headset has been previously paired with another device, switch off the headset, and press and hold the multifunction key until the indicator light starts to flash blue quickly. Activate the Bluetooth feature on the phone, and set it to search for Bluetooth devices. [. . . ] When the headset is connected to a phone but not to a separate music device, the headset can only be used to make and receive calls if the phone does not have a music player feature. The available music functions depend on your music player. If you receive or make a call while listening to music, the music is paused until you end the call. Warning: Listen to music at a moderate level. The following suggestions will help you protect your warranty coverage. [. . . ]