User manual NOKIA HOLDER EASY MOUNT HH-12

[. . . ] Nokia Holder Easy Mount HH-12 1 2 3 4 Issue 2 5 7 6 © 2006 Nokia. Nokia and Nokia Connecting People are registered trademarks of Nokia Corporation. Introduction This mounting device allows you to attach your compatible Nokia mobile holder to the windshield of your vehicle. [. . . ] The mounting device and suction cup may be damaged and adhesion may be impaired if the inside temperature exceeds +70°C (160°F). Attach to a windshield Locate a safe mounting surface on the windshield, and clean the surface thoroughly with a glass cleaner and a clean towel. If the ambient temperature is below +15°C (60°F), carefully warm the surface and the suction cup with a hair dryer to ensure a firm grip on the windshield. Ensure that you do not heat the windshield excessively to avoid damage to it. Press the suction cup at the bottom of the mounting device firmly on the windshield (see step 1 at the start of this guide), and carefully push the locking lever inside the mounting device (2) towards the suction cup to create a vacuum between the suction cup and the windshield. Check that the suction cup is firmly attached. To detach the mounting device from the windshield, carefully push the locking lever toward the top of the mounting device (3), and pull the strap located on the edge of the suction cup (4). Set to the desired position Do not adjust the mounting device while driving. To set the top of the mounting device to the desired position, loosen the two screws in the middle of the mounting device, turn the top to the desired position, and tighten the screws (5). Ensure that the top of the device is firmly locked into place. To set the mounting plate at the top of the mounting device to the desired position, loosen the screw below the plate, turn the plate to the desired position, and tighten the screw (6). Mount the mobile holder To attach a compatible Nokia mobile holder to the mounting plate, use the screw supplied with the holder. For example, to use the mobile holder CR-39, remove the protection plate with the Nokia text from the holder, attach the holder to the mounting plate with the supplied screw, and replace the protection plate (7). Insert your phone into the holder, and press the clamps at the sides of the holder until the phone is firmly in place. To release the phone, press the button below the left clamp. The mobile holder CR-39 supports mobile devices with the following dimensions: height 95 - 120 mm, width 42 - 55 mm, thickness 13 26 mm, weight 200 g at maximum. When attaching a mobile holder, ensure that the phone display is clearly visible for the user. [. . . ] · Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device. · Do not paint the device. Paint can clog the moving parts and prevent proper operation. If the product is not working properly, take it to the nearest authorized service facility for service. [. . . ]