User manual NOKIA HS-21W

[. . . ] User Guide for the Wireless Clip-on Headset (HS-21W) 9236277 Issue 1 DECLARATION OF CONFORMITY We, NOKIA CORPORATION declare under our sole responsibility that the product HS-21W is in conformity with the provisions of the following Council Directive: 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www. nokia. com/phones/ declaration_of_conformity/. Copyright © 2004 Nokia. Reproduction, transfer, distribution or storage of part or all of the contents in this document in any form without the prior written permission of Nokia is prohibited. Nokia and Nokia Connecting People are registered trademarks of Nokia Corporation. [. . . ] If the battery is completely discharged, it may take a few minutes before the red indicator is shown. Charging the battery fully may take up to 2 hours depending on the charger. When the battery is fully charged, the green indicator light is displayed. Disconnect the charger from the wall outlet and the headset. The fully charged battery has power for up to 7 hours of talk-time or up to 180 hours of standby time. (In the standby mode, the paired headset is switched on but no call is in progress. ) When the battery is running out of power, the headset beeps, and the red indicator light starts to blink. Charge the battery as described above. Switching the headset on or off To switch on, press and hold the power key for 2 seconds. The headset beeps and the green indicator light starts blinking fast. The blinking continues slower after the headset is connected to your phone. To switch off, press and hold the power key for 2 seconds. The headset beeps, and the red indicator light is displayed briefly. Copyright © 2004 Nokia. All rights reserved. 12 Pairing the headset with a compatible phone 1. Enter the Bluetooth menu of your phone, and make sure that the Bluetooth feature is activated. Enter the submenu where you can set the phone to search for Bluetooth devices, and start the search. Enter the passcode 0000 to associate ("pair") and connect the headset to your phone. In some phones you may need to make the connection separately. See the user guide of your phone for details. Once you have entered the passcode, your phone becomes the default phone for the headset, if the headset was not previously paired with another phone. See also Using the headset with several phones on page 18. The headset beeps and appears in the phone menu where you can view the Bluetooth devices that are currently paired with your phone. All rights reserved. 16 Redialing the last dialed number Press the answer/end key twice briefly when no call is in progress. Voice dialing This function is only available if your phone supports voice dialing. When no call is in progress, press and hold the answer/end key for 2 seconds, and proceed as described in the user guide of your phone. Answering and ending a call Press the answer/end key to answer the call or to end the currently active call. [. . . ] · Do not store the device in cold areas. When the device returns to its normal temperature, moisture can form inside the device and damage electronic circuit boards. · Do not attempt to open the device other than as instructed in this guide. · Do not drop, knock, or shake the device. [. . . ]