User manual NOKIA LD-3W-

[. . . ] Diversion contrary to law is prohibited. For your safety Read these simple guidelines. Not following them may be dangerous or illegal. Read the complete user guide for further information. Interference All wireless devices may be susceptible to interference, which could affect performance. [. . . ] To provide GPS location data to software applications in the Nokia 9500 Communicator, select Tools Control panel Extras Location privacy Verification policy Accept all. 3 - Battery charge indicator light 4 - Power key 5 - Release button of the back cover 6 - Charger connector Batteries and chargers The GPS module has a removable and rechargeable BL-5C battery. For availability of approved batteries and chargers, check with your local dealer. Check the model number of any charger before use with this device. This device is intended for use when supplied with power from the AC-3, AC-4, and DC-4 chargers. Use only batteries and chargers approved by Nokia for use with this particular device. The use of any other types may invalidate any approval or warranty, and may be dangerous. When you disconnect the power cord of any enhancement, grasp and pull the plug, not the cord. GPS module parts The GPS module contains the following parts shown in Figure 1 at the start of this guide: 1 - GPS indicator light 2 - Bluetooth indicator light Install the battery See Figure 2 at the start of this guide. To open the back cover of the GPS module, press the release button (1), and slide the cover away from the device (2). Close the back cover (4), and slide it in the direction of the arrow (5) until it locks into place. Charge the battery 1. Plug the charger into its connector on the GPS module. Check with your local authorities or service provider. See the user guide of your phone for a more detailed description of Bluetooth wireless technology. Pair with a compatible phone Before you can use the GPS module, you must pair it with a compatible phone. With some GPS applications, you can pair and connect the GPS module within the application without using the Bluetooth Disconnect the GPS module To disconnect the GPS module, do one of the following: · Disconnect the GPS module in the application that you used to establish the connection. · Disconnect the GPS module in the Bluetooth menu of the phone. green and red indicator lights blink alternately. Troubleshooting If you cannot connect the GPS module to a compatible phone, proceed as follows: · Ensure that the Bluetooth feature is activated on the compatible phone. · Ensure that the GPS module is switched on and paired with a compatible phone. · Ensure that you ended the previous Bluetooth connection from the phone. · Check that the GPS module is within 10 meters of the phone and that there are no obstructions or electronic devices between the two. Check the GPS module status in the night mode In some GPS applications, you can set the GPS module into the night mode. In the night mode, the indicator lights are only lit if the GPS module cannot determine its position, or if the Bluetooth connection is lost. To check the GPS module status in the night mode, press the power key quickly. The indicator lights appear briefly. Support for WAAS/EGNOS The GPS module supports the WAAS/ EGNOS system. To use the system, your GPS application needs to support it as well. [. . . ] The suggestions below will help you protect your warranty coverage. · Do not use or store the GPS module in dusty, dirty areas. Its moving parts and electronic components can be damaged. · Do not store the GPS module in hot areas. [. . . ]