User manual NOKIA MOBILE HOLDER CR-117

[. . . ] Keep them out of the reach of small children. General safety instructions Obey all local laws. Always keep your hands free to operate the vehicle while driving. Your first consideration while driving should be road safety. [. . . ] If the ambient temperature is below +15°C (60°F), carefully warm the surface and the suction cup with a hair dryer to ensure a firm grip on the windscreen. Ensure that you do not heat the windscreen excessively to avoid damage to it. Press the suction cup of the mounting device against the windscreen (see step 1C), and rotate the ring on the mounting device clockwise (1D) to create a vacuum between the suction cup and the windscreen. Check that the mounting device is firmly attached (1E). To detach the suction cup from the windscreen, rotate the ring on the mounting device anticlockwise (9), pull the strap located on the edge of the suction cup (10), and pull the holder with the mounting device from the windscreen (11). Attach to a dashboard Attach the mounting device to the dashboard If the product was supplied with an adhesive pad, you can attach the mounting device to the dashboard. Ensure that the surface where you attach the adhesive pad on the dashboard is flat, dry, and free from dirt and dust. Peel off the protective sheet from the adhesive side of the pad (see step 2A), and press the pad against the dashboard so that it stays firmly in place. When you peel off the ENGLISH protective sheet from the pad, do not touch the adhesive side. Press the suction cup of the mounting device against the pad (2B). Turn the catch on the mounting device to the desired position (2C). Rotate the ring on the mounting device clockwise (2D) to create a vacuum between the suction cup and the pad. To detach the suction cup from the pad, proceed in the same way as when you detach the cup from a windscreen (9, 10, and 11). Attach the holder to the mounting device To attach the mobile holder to the mounting device, insert the catch on the mounting device into the slot at the back of the holder (see step 2E). Rotate the holder clockwise about 90 degrees until it locks into place (2F). Check that the mounting device is firmly attached (2G). To detach the holder from the mounting device, rotate it anticlockwise. Place or remove the mobile device Do not place or remove a mobile device while driving. To place your device into the holder, lift the latch (see step 3), and turn it to the back (4). [. . . ] · Do not drop, knock, or shake the device. Rough handling can break fine mechanics. · Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device. [. . . ]