User manual NOKIA WIRELESS BOOM HEADSET HS-4W

[. . . ] User Guide for the Wireless Boom Headset (HS-4W) 9231046 Issue 1 DECLARATION OF CONFORMITY We, NOKIA CORPORATION declare under our sole responsibility that the product HS-4W is in conformity with the provisions of the following Council Directive: 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www. nokia. com/phones/declaration_of_conformity/. Copyright © 2004 Nokia. Reproduction, transfer, distribution or storage of part or all of the contents in this document in any form without the prior written permission of Nokia is prohibited. Nokia and Nokia Connecting People are registered trademarks of Nokia Corporation. [. . . ] The Wireless Boom Headset HS-4W is intended for use with the following chargers: AC-1, ACP-7, ACP-8, ACP-9, ACP-12, and LCH-12. 8 Getting started Warning!Use only batteries and chargers approved by Nokia for use with this particular enhancement. The use of any other types will invalidate any approval or warranty applying to the enhancement, and may be dangerous. For availability of approved batteries and chargers, please check with your local dealer. When you disconnect the power cord of any enhancement, grasp and pull the plug, not the cord. Charging the battery 1. Connect the charger cable to the headset as shown in Figure 2. Before connecting the charger cable to the headset, open the flap. Connect the charger to an AC wall outlet. The red indicator light is displayed during charging. Charging the battery fully may take up to 2 hours 45 minutes depending on the charger. When the battery is fully charged, the green indicator light is displayed. Disconnect the charger from the AC wall outlet and the headset. When the battery charge falls low Fully charged batteries last up to 6 hours of talk-time and up to 160 hours of standby time. (In standby mode the headset is switched on but no call is in progress. ) 9 English Getting started When the battery is running out of power, the headset beeps. Charge the battery as described above. Pairing the headset with a compatible phone 1. Make sure that the compatible phone is switched on. Activate the Bluetooth connection from the phone. For more information, see the user guide of the phone. Set the phone to search for Bluetooth devices as instructed in the user guide of the phone. Enter the generic passcode 0000 to associate ("pair") and connect the headset to the phone. Once you have entered the passcode, the phone becomes the default phone for the headset, if the headset has not been previously paired with another phone. See also Using the headset with several paired phones on page 16. The headset beeps once and an active Bluetooth connection is displayed by a blinking yellow indicator light. [. . . ] Use the battery only for its intended purpose. Never use any charger or battery which is damaged. Accidental short-circuiting can occur when a metallic object (coin, clip or pen) causes direct connection of the + and - terminals of the battery (metal strips on the battery), for example, when you carry a spare battery in your pocket or purse. Short-circuiting the terminals may damage the battery or the connecting object. 18 Battery information Leaving the battery in hot or cold places, such as in a closed car in summer or winter conditions, will reduce the capacity and lifetime of the battery. [. . . ]