User manual NOKIA WIRELESS HEADSET HS-26W

[. . . ] Except as required by applicable law, no warranties of any kind, either express or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose, are made in relation to the accuracy, reliability or contents of this document. Nokia reserves the right to revise this document or withdraw it at any time without prior notice. The availability of particular products may vary by region. Please check with the Nokia dealer nearest to you. [. . . ] To mute or unmute the ongoing call, press the middle part of the volume key briefly. · Microphone (5) picks up your voice. · Answer/end key (6) answers or ends a call. This key can also be used for voice dialing, redialing, and switching an active call between the headset and the compatible phone. · Charger connector (7) Before you can start using the headset, you must charge the battery and pair the headset with a compatible phone. 5 English 9242672_HS26W_1_en. fm Page 6 Tuesday, August 2, 2005 1:34 PM Get started Note: Parts of the headset are magnetic. Metallic materials may be attracted to the headset, and persons with a hearing aid should not hold the headset to the ear with the hearing aid. Do not place credit cards or other magnetic storage media near the headset, because information stored on them may be erased. Chargers and batteries Check the model number of any charger before using it with this device. The Nokia Wireless Headset (HS-26W) is intended for use with the AC-3, AC-4, and DC-4 chargers. Warning: Use only batteries and chargers approved by Nokia for use with this particular enhancement. The use of any other types may invalidate any approval or warranty, and may be dangerous. For availability of approved enhancements, please check with your dealer. When you disconnect the power cord of any enhancement, grasp and pull the plug, not the cord. Charge the battery This device has an internal, non-removable, rechargeable battery. Do not attempt to remove the battery from the device as you may damage the device. Connect the charger cable to the headset as shown in the figure. The red indicator light is displayed during charging. Charging the battery fully may take up to 2 hours. When the battery is fully charged, the green indicator light is displayed. Disconnect the charger from the wall outlet and the headset. The fully charged battery has power for up to 5 hours of talk-time or up to 150 hours of standby time. However, the talk and standby times may vary when used with different mobile phones, products that use a Bluetooth connection, usage settings, usage styles, and environments. 6 9242672_HS26W_1_en. fm Page 7 Tuesday, August 2, 2005 1:34 PM Get started Switch the headset on or off To switch on, press the power key for 3 seconds. The headset beeps, and the green indicator light starts to flash quickly. The flashing is slower after the headset is connected to your phone. [. . . ] Battery information Your device is powered by a rechargeable battery. · Do not store the device in cold areas. When the device returns to its normal temperature, moisture can form inside the device and damage electronic circuit boards. · Do not drop, knock, or shake the device. [. . . ]