User manual NOKIA WIRELESS HEADSET HS-36W

[. . . ] Except as required by applicable law, no warranties of any kind, either express or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose, are made in relation to the accuracy, reliability or contents of this document. Nokia reserves the right to revise this document or withdraw it at any time without prior notice. The availability of particular products may vary by region. Please check with the Nokia dealer nearest to you. [. . . ] Connect the ACP-12 charger to a wall outlet or the LCH-12 charger to the accessory power outlet of your car. The blue indicator light is continuously displayed during charging. The headset is switched off and cannot be used during charging. When the battery is fully charged, the blue indicator light switches off. Disconnect the charger from the wall outlet or the accessory power outlet and the headset. When you disconnect the power cord of the charger, grasp and pull the plug, not the cord. The fully charged battery has power for up to 6 hours of talk-time or up to 110 hours of standby time. (In the standby mode, the headset is switched on but no call is in progress. ) When the battery is running out of power, the red indicator light lights up. Charge the battery. Switch the headset on or off To switch on, press the answer/end key for about 1 second. To switch off, press and hold the answer/end key for about 5 seconds. Pair the headset with a compatible phone Make sure that the headset is on, and put it in pairing mode by pressing the answer/end key and the volume up (+) key at the same time over 5 seconds until the blue indicator light lights up. The indicator light 6 9239356_hs36w_1_en. fm Page 7 Saturday, August 20, 2005 3:25 PM Get started 1. Set the phone to search for Bluetooth devices. See the user guide of your phone for instructions. When your phone finds the headset, confirm the pairing from your phone. When prompted for the Bluetooth passcode of the headset, enter 0000. If the pairing was unsuccessful, try to pair the devices again. You only need to pair the headset with your phone once. If the pairing was successful, the blue indicator light starts to flash. The headset is now in the standby mode and ready for use. 7 English remains on for 5 minutes, during which you can pair the headset with a compatible mobile phone. 9239356_hs36w_1_en. fm Page 8 Saturday, August 20, 2005 3:25 PM Basic use 3. Basic use Wear the headset on either ear The headset is ready to wear on the right ear. If you want to use it on the left ear, gently flip (1) and rotate the earhook (2). Call handling To answer a call, press the answer key on your mobile phone, or press the answer/end key on the headset briefly. If you do not want to answer a call, press and hold the answer/end key on the headset for about 1 second. [. . . ] · Do not use or store the device in dusty, dirty areas. Its moving parts and electronic components can be damaged. · Do not store the device in hot areas. High temperatures can shorten the life of electronic devices, damage batteries, and warp or melt certain plastics. [. . . ]