User manual NOKIA WIRELESS STEREO HEADSET HS-12W

[. . . ] Other product and company names mentioned herein may be trademarks or tradenames of their respective owners. Bluetooth is a registered trademark of Bluetooth SIG, Inc. Nokia operates a policy of continuous development. Nokia reserves the right to make changes and improvements to any of the products described in this document without prior notice. [. . . ] 4 - Volume up: Increases the earphone volume during a call. 5 - Volume down: Decreases the earphone volume during a call. 6 Getting started 6 - Earphone: Relays the caller's voice. 8 - Charger connector 9 - Battery door 10 - Earloop Charging the battery The headset has a rechargeable NiMH battery. If you need to replace the battery, you can purchase a new one from your nearest authorised dealer. Connect the charger cable to the headset. For a list of compatible chargers, see Chargers and batteries on page 5. 2. Connect the charger to an AC wall outlet. The red indicator light is displayed during charging. Charging the battery fully takes between 1 and 2 hours, depending on the charger. When the battery is fully charged, the green indicator light is shown. Disconnect the charger from the AC wall outlet and the headset. When the battery charge falls low The fully charged battery has power for up to 5 hours of talk time and up to 120 hours of standby time. To change the orientation of the earpiece, detach the earloop from the body part as shown in the figure below, and place it back according to the L/R markings on the earloop. L stands for the left ear, and R stands for the right ear. When, for example, the R marking is visible, you can wear the headset on your right ear. 12 Getting started Placing the headset on the ear Slide the earloop gently behind your ear as shown in the figure below: Troubleshooting If you cannot connect the headset to your phone, proceed as follows: · Make sure that the headset is switched on and paired with your phone. · Make sure that the Bluetooth feature is activated on your phone. · Check that the headset is within a maximum of 10 meters of your phone and that there are no obstructions, such as walls, or other electronic devices between the headset and the phone. · The pairing information list of the headset may be full. The headset can store the information of up to 8 phones at a time. If the list becomes full, reset the headset to the original settings (see page 19). · If the headset does not respond to your actions, remove the battery for a short while. 13 English Using the headset 3. Using the headset Before using the headset, make sure that: · The headset is paired and connected to your phone. [. . . ] If left unused, a fully charged battery will lose its charge over time. · Temperature extremes can affect the ability of your battery to charge. · To prolong battery life of NiMh batteries, discharge the battery from time to time by leaving your headset switched on until it turns itself off. Do not attempt to discharge the battery by any other means. [. . . ]