User manual NOVAK 610-RV

[. . . ] To turn the vehicle OFF, turn the receiver pack's switch OFF. Plug the external 5 cell (1. 2 VDC/Cell) receiver battery pack into the battery slot of the receiver. Unplug the ESC's red wire from the input harness going to the receiver. Insulate the red wire to keep it from shorting. [. . . ] Traxxas@-compatible 14G plug harness for easy and low resistance connections. TIMING PRODUCES DANGEROUSLY HIGH SPEEDS When Novak's advanced timing is activated, the resulting vehicle speed can be dangerously high. It is important to take extra precautions. Schottky diodes are never to be used with brushless ESCs. Do not use Schottky diodes with Havoc Pro SC ESC!This includes running the motor without a pinion or holding the car in the air and running the motor at or close to full power. Always disconnect batteries from ESC to avoid short circuits and possible fire hazard. If using LiPo or LiFe battery packs, use a 2-cell (2S) pack for the vehicle's main battery & be sure the Voltage Cut-Off programming option is turned ON (refer to Track Guide). If using NiCd or NiMH batteries, NEVER use more than 6 cells (1. 2VDC/cell) in the vehicle's main battery pack, and disable Voltage Cut-Off Circuitry (refer to Track Guide). Reverse battery polarity can damage ESC & void warranty. Disconnect battery immediately if a reverse connection occurs. An external 2S Power Trans-Cap module is installed on ESC & MUST be used at all times. By the act of connecting/ operating speed control, user accepts all resulting liability. In no case shall our liability exceed the product's original cost. We reserve the right to modify warranty provisions without notice. This product is not intended for use by children under 14 years of age without the strict supervision of an adult. Use of this product in an uncontrolled manner may result in physical damage or injuries--take extra care when operating any remote control vehicle. in Irvine, CA and assembled with globally sourced components. · All Rights Reserved · No part of these instructions may be reproduced without the written permission of Novak Electronics, Inc. 6 piece assortment in Novak kit #5850, and 24 piece assortment in Novak kit #5851. DO NOT BUNDLE POWER & SIGNAL WIRES TOGETHER RF noise in the power wires can adversely effect radio system performance. Always insulate exposed wiring with heat shrink tubing or electrical tape to prevent short circuits, which can damage the ESC. Exposure to CA glue or its fumes can cause damage to internal components of the ESC and result in premature failure. INSULATE WIRES NO CA GLUE www. teamnovak. com TRAXXAS® SLASHTM 4X4 ESC MOUNTING PLATE [Novak kit #5090) Mounting plate and hardware to install ESC into Traxxas® SlashTM 4x4. P4 P1 step 1­connect input harness HAVOC 610-RV 550-SIZED SET-UP PHOTO The Havoc Pro SC has a userreplaceable input harness with a 2mm mini plug on the ESC end of it and the industry-standard connector on the receiver end of it. The Havoc Pro SC works with all major radio brand's new receivers [Refer to Figure 1 to see how to connect the included user-replaceable input harness]. [. . . ] Tightly twist the exposed strands of wire and tin with solder. Place the ESC's BLUE Phase `A' motor wire onto motor's `A' solder tab & solder. Use a soldering iron to apply heat to exposed wire; begin adding solder to tip of soldering iron & to wire. Add just enough solder to form a clean & continuous joint from the plated area of the solder tab up onto the wire. [. . . ]