User manual NUMARK CDN-90

[. . . ] Premium CD Player MANUAL ©2002 Industries http://www. numark. com CDN90 SAFETY INSTRUCTIONS a) b) c) d) e) f) Read Instructions - All the safety and operating instructions should be read before this product is connected and used. Retain Instructions - The safety and operating instructions should be kept for future reference. Heed Warnings - All warnings on this product and in these operating instructions should be followed. Follow Instructions - All operating and other instructions should be followed. [. . . ] Options will appear to relay immediately after the track (0), with time added of 1, 2, 3 or 4 seconds (1, 2, 3, 4), or a reduction of 3, 2, or 1 seconds (-3, -2, -1). By reducing time the tracks will crossover before the end of a track, creating an automatic segue from master to slave. This feature will also work in track sequence program mode; however, if the sides are also in SINGLE mode the same number of tracks programmed should be the same. Play will stop at the end of the last track. Fader Start/Remote Switch Start This function will allow for CD player control using most standard fader start compatible mixers and switches. First you must follow the directions for connecting to your fader start compatible mixer or switch. Set the CD player to the proper switch mode by holding down followed by tapping then CD player will activate with fader start. Typically if you move the crossfader toward If the display shows the active channel, the attached CD player will activate. When it is moved away the unit will cue or pause depending upon CD player setting. If the display says then the CD player will activate with an ON-OFF pushbutton switch generally used for switching channels on guitar amps If the display says pedals. then the CD player will activate with a momentary switch usually used for keyboard sustain Note: You can also use a momentary switch in the ON-OFF switch position. In this case the unit will only play while the switch is depressed. When the button is release it will either cue or pause depending upon mode 2. Select start/stop mode hold the time button for 2 seconds. If the display shows then the CD will pause when stopped. If the display shows then the CD will RE-CUE when stopped. - The Leader in DJ Technology ©2002 Numark Industries - 13 http://www. numark. com CDN90 LOOPING OPERATIONS LOOPING: A loop is any area of a CD that you choose to repeat with no breaks. On the CDN90 two seamless loops are possible. LOOP IN: The "LOOP IN" point is where you wish for the loop to start. The initial "CUE" point of the CD is also the default "LOOP IN" point for both loops or "Hot Start" point. If you wish to set a new "LOOP IN" point, just press the CD is playing when it reaches the desired point. The button will light indicating a new loop is set. The button while and in the display will also illuminate indicating a point has been set and is accessible for "STUTTER". By default the "LOOP IN" also becomes the "STUTTER" or "HOT START" point. NOTE: The CD Player will always remember a new set point as the "LOOP IN" or "HOT START" point until you actually set a new "LOOP IN" point or put in a new CD. The new point will be accessible until you remove the CD from the unit. [. . . ] All replaced parts, components, boards and equipment become the property of NUMARK. If NUMARK determines that any mixer is not covered by this Limited Warranty, purchaser must pay all parts, shipping, and labor charges for the repair or return of such mixer. What are the limits on NUMARK'S liabilities?THE WARRANTIES GIVEN IN THIS LIMITED WARRANTY, TOGETHER WITH ANY IMPLIED WARRANTIES COVERING NUMARK MIXERS, INCLUDING WITHOUT LIMITATION ANY WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO THE DURATION OF THIS LIMITED WARRANTY. [. . . ]