User manual NUMARK CDN22MKIII Operating Manual

[. . . ] ® Professional Disc Jockey Products CDN-22MK III PROFESSIONAL DUAL CD PLAYER OPERATING MANUAL ©2002 Industries http://www. numark. com CDN-22MK III Safety Information and Product Registration CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE ANY COVER. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL ONLY. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the user to the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying this appliance. 7. [. . . ] Press CUE to return to the "CUE POINT". b) The jog wheel will temporarily bend the pitch of the music if the song is already playing by rotating the wheel clockwise to speed up or counterclockwise to slow down. CUE - Pressing the CUE button during play provides a return to the position at which play was started. If PAUSE is used before CUE, that will become the cue point. Alternately pressing the PLAY button and the CUE button allows the CD to be played from the same position any number of times. The CUE LED will light up from the time the CUE button is pressed until the CD has reset to the position at which play was started. Steady lighting of this LED indicates the ready condition. START/PAUSE (Play/Pause Button) - Each press of the Play/Pause Button causes the operation to change from play to pause or from pause to play. PITCH SLIDER - The pitch can be changed up to +/12% by pressing the PITCH button so the PITCH LED is lit, then moving the sliding fader. The pitch will not be changed if the PITCH LED is off. 1. PROGRAM - Depress this button and the unit will stop and the program indicator will light. Select each track to be programmed and press the PROGRAM button between selections. To exit and erase program hold the program button down for more than 2 seconds while the unit is stopped, open the disc tray, or turn off the power. CONT/SING - Will cause just a single track to play or all tracks in order by pressing once or twice. LCD DISPLAY - Indicates all the functions, as they are occurring, with the CD. These functions are explained in the next section. TIME (Time Button) - The TIME button switches the time display between elapsed playing time and remaining time on the track. Holding for more than one second activates auto-start functions. OPEN/CLOSE (Disc Tray Open/Close) - Press to load or eject the disc. Each press will open or close the disc tray on the transport. NOTE: Tray will not open unless the disc has been paused. TRACK (Track Buttons) - These buttons are used to select the track to be played. [. . . ] Both sides must be active for relay to work. Put both sides in SINGLE play mode while learning this function. When that CD1 has finished play it will send a signal to CD2 to start play. You will see CD2 start play and CD1 pause and cue to the beginning of the next track. [. . . ]