User manual NUMARK DM950

[. . . ] DM-950 DJ Mixer Operating Instructions INSIDE THE BOX: (1) DM-950 DJ Mixer (1) DM-950 Power Adapter Thank you for buying this Numark product package. Please read these operating instructions so you will know how to operate all of this equipment properly. After you have finished reading these instructions, keep them for future reference. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. [. . . ] A Red Power LED indicates that the unit has been switched on. 2. Master Volume This rotary control adjusts the main output levels for any equipment connected to the Master Output on the rear panel (B. ) Turning the knob completely to the right increases the level and turning the knob completely to the left decreases the level. 3. CH 1 Trim, Treble and Bass "Trim" (Input Level Trim) (4. applies to CH 2) This rotary control adjusts the input signal levels of the inputs. Turning the knob completely to the right (clockwise) increases the level. Turning the knob completely to the left (counter clockwise) decreases the level. "Treble" (Input Level High EQ) This rotary control adjusts the high-tone sound of the inputs. Turning the knob completely to the right increases the level. Turning the knob completely to the left decreases the level. "Bass" (Input Level Low EQ) This rotary control adjusts the low-tone sound of the inputs. Turning the knob completely to the right increases the level. Turning the knob completely to the left decreases the level. 5. Microphone Trim One microphone can be connected to the Quarter Inch output terminal (G). The Microphone Trim should always be at its lowest setting while connecting and disconnecting a microphone to prevent damage to the mixer and/or your audience. 6. CH 1 Input Selector Switch This two position Toggle Switch engages the Phone Input in the upward position (F) or the Line Level Input in the downward position (E. ) 7. CH 2 Input Selector Switch This two position Toggle Switch engages the Phone Input in the upward position (D) or the Line Level Input in the downward position (C. ) 8. CH 1 Input Fader This slide fader continually adjusts the level of the selected CH 1 input sources (See Control 6. ) In the full upward position, the level is set to the maximum output. 9. CH 2 Input Fader This slide fader continually adjusts the level of the selected CH 2 input sources (See Control 7. ) In the full upward position, the level is set to the maximum output. 10. CH 1 and CH 2 Crossfader This slide fader blends between the assigned inputs set by the Input Selector Switches (6 and 7). In the full left position, only CH 1 is sent to the Master Output (B. ) In the full right position, only CH 2 is sent to the Master Output. In the center position, a mix of the levels of CH 1 and CH 2 are combined and sent to the output. 11. Mini Slide Fader Cueing System This mini slide fader can be used as a "Crossfader" for previewing mixes in the connected headphones (H. ) The level of the headphones is adjusted using the Cue Trim knob. [. . . ] Accordingly, additional statements such as dealer advertising or presentation, whether oral or written, do not constitute warranties by NUMARK and should not be relied upon. How does state law apply to this warranty?SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATIONS OF INCIDENTAL OR CONSEQUENTIAL DAMAGES OR HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO PURCHASER. This Limited Warranty gives you specific legal rights. [. . . ]