User manual NUMARK PPD01

[. . . ] USER'S MANUAL ©2002 Industries http://www. numark. com PPD01 SAFETY INSTRUCTIONS a) b) c) d) e) f) Read Instructions - All the safety and operating instructions should be read before this product is connected and used. Retain Instructions - The safety and operating instructions should be kept for future reference. Heed Warnings - All warnings on this product and in these operating instructions should be followed. Follow Instructions - All operating and other instructions should be followed. [. . . ] When CH1 CH2 is indicated the meter shows the peak, "PFL", Pre Fader levels of channels 1 and 2. You can use the channel "Gain" and "EQ" controls to match the levels of input signals while cueing 13. "Cue Gain Knob" (Headphone Level): This rotary control adjusts the levels of the headphones connected to the front panel input. "Cue Tone Knob" (Headphone Tone Control): This rotary knob adjusts the tone of the headphone output. The knob can be raised and lowered to hide away by pressing it down. "Channel Cue Slider": Channels 1 and 2 can be previewed using this mini-crossfader. Sliding this to the left plays the left channel-1 and sliding to the right plays the right channel-2. "Cue Button" (MIC and MASTER Cue Buttons): When pressed, the CUE button illuminates green indicating that the source is being cued to the headphones. When you press Mic PFL it adds it to the cue mix. When Master Cue is pressed only the master output is heard. "Headphone Jack" (Quarter Inch Output Terminal): Your headphones can be connected to this ¼" terminals. The Volume should always be set at its lowest setting while connecting and disconnecting headphones to prevent damage to headphones and/or your hearing. "Crossfader Slider" (Digital VCA Crossfader): This slide fader blends audio between CH-1 and CH-2. Its action can be modified with the "Mode" , "Slope", and "Direction" controls. This digital mixer uses digital VCA technology to accurately determine slider position. Both the VCA and Digital technologies combined allow for some very powerful effects. Note: This fader is user replaceable if it should ever wear out. Simply remove the facepanel and then remove the screws holding it in position. Replace the fader with a quality authorized replacement from your local Numark retailer. "MODE and MODE Display" (Crossfader Function Control and Display): This toggle switch changes crossfader modes be left-right movement. The current mode is indicated in the mode display under the crossfader. These modes are described in detail in the section entitled "CROSSFADER MODES". [. . . ] If NUMARK determines that any mixer is not covered by this Limited Warranty, purchaser must pay all parts, shipping, and labor charges for the repair or return of such mixer. What are the limits on NUMARK'S liabilities?THE WARRANTIES GIVEN IN THIS LIMITED WARRANTY, TOGETHER WITH ANY IMPLIED WARRANTIES COVERING NUMARK MIXERS, INCLUDING WITHOUT LIMITATION ANY WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO THE DURATION OF THIS LIMITED WARRANTY. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, NUMARK SHALL NOT BE LIABLE FOR ANY SPECIAL, INCIDENTAL, CONSEQUENTIAL, INDIRECT OR SIMILAR DAMAGES, LOSS OF PROFITS, DAMAGES TO PURCHASER'S PROPERTY, OR INJURY TO PURCHASER OR OTHERS ARISING OUT OF THE USE, MISUSE OR INABILITY TO USE ANY NUMARK MIXER, BREACH OF WARRANTY, OR NEGLIGENCE, INCLUDING BUT NOT LIMITED TO NUMARK'S OWN NEGLIGENCE, EVEN IF NUMARK OR ITS AGENT HAS BEEN ADVISED OF SUCH DAMAGES, OR FOR ANY CLAIM BROUGHT AGAINST PURCHASER BY ANY OTHER PARTY. [. . . ]