User manual NUMARK TT1510

[. . . ] Power Cord Protection - Power supply cords should be routed so that they are not likely to be walked upon or pinched by items placed on or against them. When removing the cord from a power outlet be sure to remove it by holding the plug attachment and not by pulling on the cord. Object and Liquid Entry - Take care that objects do not fall into and that liquids are not spilled into the inside of the mixer. Cleaning ­ The appliance should be cleaned only as recommended by the manufacturer. [. . . ] Slide counterweight onto the rear of the tonearm. Twist it lightly and it will screw onto the rear shaft of the tonearm. Tonearm Counterweight - The Leader in DJ Technology ©2000 Industries -5http://www. numark. com TT1510 10. Adjustment of horizontal zero (O) balance with stylus pressure and anti-skating : a. Do not touch the stylus tip during the adjustment. Set the cueing lever to the lower position so it does not effect tone arm height. Release the arm clamp and lift the tonearm from the armrest so it moves freely. Rotate the counterweight until the tonearm is approximately balanced horizontally (floats freely). e. Refasten the tonearm with the arm clamp. Hold the counterweight stationary with one hand and rotate only the styluspressure ring to bring the number "O" of the ring into alignment with the center line on the tonearm rear shaft. Rotate the counterweight with scale ring clockwise to the correct stylus pressure following the manufacturer's recommendation. Set the anti-skating control knob to the same value as the stylus pressure unless your manufacturer specifies otherwise 11. Install the dust cover to the main unit. This lid is not designed for continual removal. If you need to remove the lid press both release tabs at the same time. CONNECTIONS 1. Connect the power cord to the power outlet. Connect the unit's output terminals from the rear of the unit to the PHONO jack of your DJ mixer or home amplifier/receiver. Output terminals L (White) --------------> R (Red) ----------------> GND (Spade) --------> Phono input of mixer L Channel R Channel GND Notes: Be sure to connect the ground terminal firmly to the amplifier or receiver. If this connection is not loose, a power source "HUM" may result. - The Leader in DJ Technology ©2000 Industries -6http://www. numark. com TT1510 OPERATING INSTRUCTIONS 1. Push the power button to turn on the power. The speed indicator and the strobe-illuminator will light up. When playing a 45rpm record with a large center hole, place the 45-rpm adapter on the center spindle. Set the rotation speed (33/45) to match the record. [. . . ] You may also have other rights, which vary from one jurisdiction to another. RETURN INFORMATION a) b) c) d) e) f) g) A Return Authorization number must be obtained from Numark through the address or phone numbers below. A copy of the original sales receipt must also be included for the equipment to be repaired under warranty. The faulty equipment must be packed in its original packaging. One additional outer layer of packaging must be included to ensure product safety. [. . . ]