User manual OBH NORDICA LH42Q8S0

[. . . ] Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply. Always disconnect the appliance from the mains power supply when it is unattended and before assembling, dismantling or cleaning it. Remember: you may injure yourself if you use the appliance incorrectly. Do not use the appliance if it is not working properly or if it has been damaged. [. . . ] Your appliance contains valuable materials which can be recovered or recycled. Leave it at a local civic waste collection point. The accessories supplied with the model that you have purchased are shown on the label on the top of the packaging. WARNING: Read the instructions for use carefully before using your appliance for the first time: the manufacturer shall accept no liability in the event of any use that does not comply with the instructions. Keep them in a safe place so that you can refer to them later. The appliance can only operate when the jug (C) or the accessories (D or E) are correctly positioned and locked on the motor unit (A). Before you use your appliance for the first time, clean all the accessories (C, D, E, F) using hot soapy water, except for the motor unit (A). WARNING: The blades are extremely sharp so handle them carefully when using and cleaning the appliance. Verify that the packaging has been removed before using the appliance. Important note: Turn the speed selector (B) to "0" before placing the Blender jug or the accessories on the motor unit. The appliance will only start if the jug or the accessory is correctly Positioned and locked on the motor unit. WARNING: Do not use the blender if the lid is not in place. Do not use the blender without ingredients or solid ingredients only. Correctly position the seal (C3) on the blade (C2) (Fig. Clip the blade (C2) on the blade support (C1) (Fig. 2) · Place the blade assembly (C1, C2, C3) on the jug (C4) and lock it by Put the ingredients in the assembled jug without exceeding the maximum level indicated: * 1. 25 L for thick preparations * 1 L for liquid preparations · Warning: Do not process boiling liquids (over 80ºC/176ºF) in the blender jug. Place the measuring cap (C6) in the lid opening (Fig. Place the assembled jug (C) on the motor unit (A). The open lock is aligned with the arrow on the jug (Fig. Then turn the blender jug (C4) a quarter turn until the closed lock is aligned with the arrow of the jug (Fig. Plug in the unit and turn it on by turning the speed selector to the desired position or apply a few pulses. [. . . ] Plug the appliance into an electrical outlet and turn The appliance does not work. The jug or the accessory is not correctly positioned or locked on Check that the jug or the accessory is properly positioned and locked in the motor unit as shown on the images of the Instructions The appliance is not placed on a flat, stable and heat-resistant surface. Reduce the quantity of ingredients in the appliance. Reduce the quantity of ingredients in the appliance. [. . . ]