User manual OKI C5300NCCS REFERENCE GUIDE

[. . . ] Every effort has been made to ensure that the information in this document is complete, accurate, and up-to-date. Oki assumes no responsibility for the results of errors beyond its control. Oki also cannot guarantee that changes in software and equipment made by other manufacturers and referred to in this guide will not affect the applicability of the information in it. Mention of software products manufactured by other companies does not necessarily constitute endorsement by Oki. [. . . ] Microsoft provides on-line help with all of their operating systems and this is a good reference point for the exact details of each configuration option within Windows. The network printer supports the following protocols that can be used in conjunction with the Windows operating system: > > > TCP/IP IPX (Novell NetWare) NetBEUI There are a number of options available when printing using TCP/IP for Windows. Into Windows and are displayed as options when using the Add Printer Wizard. Although there are some differences in configuration options between the various Windows platforms, the procedure for printing using TCP/IP is the same. This can be confirmed by checking the network settings from within the Control Panel. If TCP/IP has not been installed refer to the section below Installation of TCP/IP protocol. If not already configured, a suitable IP address, Subnet Mask and Gateway address should be configured. If your network environment uses domain names, DNS should be enabled and configured on your system. However, this step is not essential to enable network printing. In the [Select Network Component Type] dialogue box, select [Protocol] then click [Add]. In the [Select Network Protocol] dialogue box, select [Microsoft] from the list of manufacturers, then select [TCP/IP] from the list of network protocols, then click [OK]. the Windows installation CD-ROM may be required. Follow the remaining dialogue box prompts. Follow the remaining dialogue box prompts. In the [Select Network Component Type] dialogue box, select [Protocol] then click [Add]. In the [Select Network Protocol] dialogue box, select [Internet Protocol (TCP/IP)] then click [OK]. Follow the remaining dialogue box prompts. Once the protocol has been installed and configured in Windows, the next step is to configure the TCP/IP parameters in the network printer. Select the appropriate network card, using the Ethernet address to identify it, and click [Next]. The Ethernet address (MAC Address) of the printer can be found on the self-diagnostic printout, which can be printed by pressing the push-button on the network card for two seconds and then releasing it. When using lpr in UNIX and other TCP/IP environments, please select [Yes]. To use in a TCP/IP environment, an IP address should be assigned to the Ethernet board. [. . . ] Network addresses used in your installation must be generated from your own network. Confirm that the NIC is installed correctly in models that require an optional NIC card and turn the printer off and on again. Ensure the network cable is correctly connected and connect to a different network segment, rerun the test and see if this cures the fault. Confirm that the NIC is installed correctly and turn the printer off and on again. [. . . ]