User manual OLIMPIA SPLENDID DJ TECNO CERAMICO

[. . . ] Health and the environment are endangered by incorrect disposal. Further information about the recycling of this product can be obtained from your local town hall, your refuse collection service, or in the store at which you bought the product. This regulation is valid only in EU member states. 1 Only use this appliance once you have read the warnings given in this manual. [. . . ] 1) Control panel knobs (DJ CERAMICO only) 2) Control panel (DJ TECNO CERAMICO only) 3) LCD display (DJ TECNO CERAMICO only) 4) On/off light, minimum power, maximum power 5) Air outlet grill 6) Base 7) Handle 8) Air suction grill + filter 9) On/off key 10) Power plug In case of doubt, do not use and contact a qualified technician. the packing (plastic bags , expanded polystyrene , etc. ) must be kept out of reach of children due to potential hazard; packing must be disposed of according to current regulations. Before connecting the appliance check that the voltage values shown on the rating plate match those of the mains system, and that the socket is earthed. If the appliance's plug is incompatible with the socket, have the socket replaced with a suitable one by a qualified technician, who must ascertain that the section of the socket cables is compatible with the power absorbed by the appliance. We do not recommend using adaptors and/or extension cables. If they cannot be avoided, however, they must comply with current safety regulations and their ampacity (A) must not be below the maximum ampacity of the appliance. Before using the heater ensure it is placed on a stable, flat surface; if not, damage may occur. The socket must be easily accessible so that the plug can be removed easily in an emergency. This appliance is not intended to be run via an external timer or with a separate remote control system. In the event of a fault or malfunction, switch off the appliance and have it checked by a qualified technician. When the plug is inserted in the socket and the on/off key is pressed, the on/ off light switches on to indicate that the appliance is powered (fig. The red light remains lit until the on/off key is switched off or the heater is unplugged. A) clockwise to max position, then turn the power selector (fig. To select the required power, turn the power selector (fig. B) from (ventilation) to I (low) or II (high): I (low) indicates consumption of 1100 W while II (high) indicates 1800 W. SW1: SW2: ON /Standby; Operating mode selection (ventilation max speed - minimum power - maximum power automatic - frost protection ventilation max speed . ); Fan speed selection (max speed min speed - max speed. The appliance can be switched on and set to stand-by (temporary stop) for brief periods by pressing SW1 on the control panel (if the appliance is unused for prolonged periods, it must be switched off using the button on the back of the appliance and then unplugged). In STANDBY mode the display shows the following " ". With the appliance in STANDBY, all previously set timers and functions are reset. Starting in stand-by mode, this mode can be accessed by pressing key SW2 once and the fan symbol and the word MAX ( , ) appear on the control panel display. [. . . ] After confirming the activation of the timer, the operating mode can be changed at any time by pressing SW2. Once the set time has elapsed, the unit will go to stand-by mode. The heater can only restart once the user has reset it (see RESET INSTRUCTIONS) 2 After 5-10 minutes, plug the heater back in and it will start running normally. Remove the back air suction grill by pressing the upper tab and then pulling it out (fig. [. . . ]